Galiso 21-11-1008 Petunjuk Perakitan, Pemasangan, dan Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Perakitan, Pemasangan, dan Pengoperasian untuk Peralatan Industri Galiso 21-11-1008. Galiso 21-11-1008 10 halaman.

Halaman Cetak

2.0 Installation, continued

E. Remove the 5/32" plug from the Valve Stack Port for slot two. Insert the free end

of the 5/32" O.D. green tube (item E) into this Port.

F. Fill the Cylinder with a suitable, oxygen compatible detergent or cleaning

solution. The level of the detergent should be 6" below the bottom of the threads

in the Cylinder Neck. Use an oxygen compatible, liquid degreaser, water soluble

soap such as SD-13. SD-13 is available from Galiso, Incorporated at (800) 854-

3789 or visit the website at www.galiso.com.

NOTE: Certain types of detergents and cylinder cleaning solutions are not compatible

with aluminum cylinders. Galiso, Inc. recommends using a steel cylinder as the

Detergent Reservoir.

Put Teflon tape around the threads on the Probe and screw into the neck of the

Detergent Reservoir Cylinder.

G. Install the Soap Probe (item F) into a clean, low pressure Cylinder with a ¾" NPT

neck opening. The bottom of the Dip Tube may need to be trimmed prior to

installation. The length of the Dip Tube should allow approximately 3" between

the end of the Dip tube and the bottom of the cylinder (after fully installed in the

Cylinder Neck).

Section 2 - 3

Remove the

"T" plug and

insert Item E.

21-11-1008