Emerson Amphora F2200TG02 Panduan Pemilik - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Kipas angin Emerson Amphora F2200TG02. Emerson Amphora F2200TG02 12 halaman. Derby & amphora series
Halaman Cetak
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver
Three wire connectors (supplied.)
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
size:
For your convenience, check-off boxes are provided next to each step. As each step is
completed, place a check mark in the box. This will insure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson. Substitution of parts or accessories not
designated for use with this product by Emerson
could result in personal injury or property damage.
1. Open styrofoam unit containing fan. Remove top
half of styrofoam unit. Remove parts and check to
see that you have received the following:
a. Fan motor and housing assembly
b. One motor cover
c. One ceiling cover
d. Five blade flanges
e. One hanger ball/downrod assembly
f. One hanger bracket
g. One switch housing cover
h. One finial (Amphora only)
i. One loose parts bag containing:
1. One setscrew
2. One 5/32" hex wrench
3. Eleven 10-32 x 5/8" oval head screws
4. Two 1" threaded studs
5. Two 1-1/4" threaded studs
6. Four knurled knobs
7. Three wire connectors
8. Two screws 8-32 x 3/8" (Derby only)
9. Two pull chain pendants, and couplings
10. One hairpin clip
11. One clevis pin
12. Two lockwashers
13. Sixteen 10-32 x 3/8" pan head screws
14. Sixteen flat washers
15. 1/8-27 x 1-1/2" Threaded nipple
(Amphora only)
One stepladder
One wire stripper
Unpacking Instructions
3
Installed Wire Length
Up to 50 ft.
50-100 ft.
WARNING
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (see page 6). If you
feel you do not have enough wiring knowledge or expe-
rience, have your fan installed by a licensed electrician.
NOTE: Place the parts from the loose parts bags
in small containers to keep them from being lost.
If any parts are missing, contact your local retail-
er or catalog outlet for replacement before pro-
ceeding.
NOTE: Fan blades are ordered separately and are
packaged in separate carton.
SWITCH
HOUSING
COVER
CEILING
COVER
FOAM
PACKING
PROTECTIVE
PLASTIC BAG
FOAM
PACKING
Wire Size A.W.G.
14
12
BLADE
FLANGES
LOOSE
PARTS BAG
HANGER
HANGER BALL/
BRACKET
DOWNROD
ASSEMBLY
MOTOR AND
HOUSING ASSEMBLY
MOTOR
COVER
CARTON