HighGear Summit Panduan Pengguna - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Menonton HighGear Summit. HighGear Summit 20 halaman. Time, compass, barometer, altimeter, chronograph, and alarm
Juga untuk HighGear Summit: Panduan Referensi Cepat (2 halaman)
Halaman Cetak
KEYS AND THEIR FUNCTIONS
TABLE OF CONTENTS
The Summit/Altitech 2 is equipped with 4 individual keys. Each key has several functions listed below.
S1 KEY
- Changes View in Time, Barometer, Altimeter, Altimeter
Log and Chronograph Log modes
- Start/Stop information storage in Altimeter mode
- Advances variable in Setting mode
- Start/Lap/Split action in Chronograph mode
- Turns Daily Alarm On/Off
S2 KEY
- View/Select Time 1 / Time 2 in Time of Day mode
- View/Select C/F in Barometer mode
- View/Select Ft/M in Altimeter mode
- Scroll through Altitude Log files
- Stop Chronograph/Save Chronograph Files
- Scroll through Chronograph Log files
- Select Alarm 1 or 2
S3 KEY
- Advances display through the various operational
modes
- Selects variable in setting mode
S4 KEY
- Enter/Exit Setting mode for each function
- Clear Chronograph and Altimeter memories -
9
ALTIWARE SERIES
SUMMIT
ALTITECH 2
S2
S3
-
KEYS AND THEIR FUNCTIONS
TABLE OF CONTENTS
KEY ACTIONS – QUICK PRESS VS. PRESS AND HOLD
There are two key actions used to program the watch:
QUICK PRESS
The key is pressed quickly and immediately released. This is the most common key action and is
used for most aspects of the watches operation.
PRESS & HOLD
The key is pressed and held for 2-3 seconds. This key action is generally used to initiate a
programming sequence or to change an on screen variable.
NOTE:
Generally, when a
the center line of the display.
NOTE:
In this manual we will indicate when a
instances, if not specifically stated, a
PROGRAMMING THE WATCH – COMMON KEY ACTIONS
The following are key presses required to perform the most common operations.
ENTER A PROGRAMMING SEQUENCE
PRESS & HOLD
S1
The words ADJUST – HOLD will appear in the top and center lines of the display. Continue to hold
the key until the display automatically advances to the first variable in the programming sequence.
ADJUST VARIABLE IN A PROGRAMMING SEQUENCE
QUICK PRESS
the
Variables in a programming sequence are adjusted up using
S4
down using
QUICK PRESSES
In most programming options, a
to fast advance, allowing you to quickly advance to a different number.
Continued next page.
PRESS & HOLD
action is required, the word
PRESS & HOLD
QUICK PRESS
should be assumed.
the
S4
key.
S1
&
S2
keys.
QUICK PRESSES
of the
S2
key.
PRESS & HOLD
of either the
summit/altitech 2
HOLD
will appear on
is required. In most other
of the
S1
key and
S1
or
S2
key will cause the variable
10