AutoSat GPS-GPRS Video Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alarm Mobil AutoSat GPS-GPRS Video. AutoSat GPS-GPRS Video 8 halaman. Satellite car alarm

Halaman Cetak
ENGLISH
7
.0. CABLE ASSEMBLY
Included with the AutoSat kit is a 12 pole cable assembly for easy installation of the system.
Below in Fig. 3 you will see this assembly along with the description of each cable + colour.
BLADE
PORTAFUSE
Cable legend
→ Negative (GND)
1 - Black
→ STAND-BY. Normally open contact. Connection to ground puts the
2 - Orange-Blue
system in stand-by mode (see Page 4).
→ Input alarm 1.
3 - Blue-Black
AutoSat will trigger an alarm if this input is connected to GND.
→ Input alarm 2.
4 - Blue-Orange
AutoSat will trigger an alarm if this input is connected to GND.
→ Input alarm 3.
5 - Blue
AutoSat will trigger an alarm if this input is connected to GND.
→ Common (C) alarm relay
6 - Green
→ Normally closed (NC) alarm relay
7 - Green-White
8 - Green-Orange → Normally open (NA) alarm relay
→ "Open Collector" output. This terminal can be used
9 - Yellow
to connect a flash that will be activate when
photos are taken - (Imax = 2 A).
For connection the flash see figure on the right.
→ Not present in this version
10 -
→ Not present in this version
11 -
→ Positive from +11 Vdc to 24 Vdc (with a 3 A fuse in series)
12 - Red
Page 14
BLADE
PORTAFUSE
Fig. 3
+ 12 Vdc
Flash
To the
output 9
(Yellow)
AutoSat GPS - GPRS video instruction manual
2

.0. INSTALLATION AND POWER-UP

Before proceeding to install the AutoSat, it is necessary to purchase a SIM card capable of
handling GPRS traffic.
This card must not have a PIN code inserted. If it does, it must be cancelled.
Follow the instructions below:
•
Insert the SIM card into the slot shown in Fig. 2 below.
•
Connect both the GPS & GPRS antennas to the connectors shown in Fig. 2.
•
Plug-in the digital camera (maximum 3) in the slots shown in Fig. 1 (optional).
•
Insert the cable assembly 12 poles in the connector as indicated in Fig. 1.
•
Connect the listen-in kit (optional) to the connector indicated in Fig. 1.
•
Rotate the key switch to "ON" position to power-up the unit.
FRONT SIDE
RJ-45
connector
assembly input
Indicator
CAM1 CAM2 CAM3
LED
BACK SIDE
LED
Modem status
Antenna
SIM card
GPRS
slot
connector
AutoSat GPS - GPRS video instruction manual
ENGLISH
12 pole cable
ON/OFF
key
Fig. 1
Listen-in
kit
SIM card
door
Fig. 2
LED GPS
Antenna
FIX
GPS
connector
Page 3