AutoSat GPS-GPRS Video Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alarm Mobil AutoSat GPS-GPRS Video. AutoSat GPS-GPRS Video 8 halaman. Satellite car alarm

Halaman Cetak
ENGLISH
3
3
.
. Request by SMS with SMS and e-mail replay
Request for e-mail with pre-programmed file showing the vehicle
co-ordinates and the speed (command "!LGPS")
The AutoSat after having received the command DELG#PSW#S, will start memorizing the
position and speed of the vehicle.
The gathering of information is done by memorizing the vehicle position every 10 seconds
or if the change in distance, from point to point, is more than 100 meter from the previous
acquisition.
The AutoSat can memorize up to 18,000 points which corresponds to 1,800 Km.
The coordinates and speed are contained in 2 files (GPS_coarse.txt. GPS_speed.txt)
enclosed in an e-mail that may be requested by sending an SMS command message to the
AutoSat using the following format:
!LGPS#PSW#
Example: !LGPS#1234#
AutoSat replies: Request LGPS accepted.
Info GPS: speed 26 km/h; latitude 41,7112 north; longitude 12,6284 east.
NOTE
If it is not possible to send an e-mail, the requesting telephone number will
receive an SMS message which indicates the reason of the e-mail failure
(see paragraph 6.0. on Page 13).
Replay e-mail format
Page 10
Last acquisition
AutoSat GPS - GPRS video instruction manual
Regulating of the resolution installed cameras (command "!RISF")
It is possible to set by remote the resolution of the cameras installed with the AutoSat by
sending an SMS message to the AutoSat using the format shown below:
!RISF#PSW#r
where:
r
= 1 for 80x64 pixels
i
r
= 5 for 320x240 pixels
i
Example: !RISF#1234#537#
AutoSat replies: Ris Cam 1: 320x240. Ris Cam 2: 160x128. Ris Cam 3: 640x480.
NOTE
The factory set resolution is 160x128.
To give the AutoSat an identification number (ID) (command "!IDAS")
To use the AutoSat with a monitoring station, you must give each unit an 8 digit
identification number called ID. Each unit installed must have its own ID number.
NOTE The ID must be made-up of 8 numbers.
The factory supplied ID is 999999999.
To create this ID, you must send an SMS message to the SIM card of the AutoSat using
the format below:
!IDAS#PSW#ID#
For an ID of 8 numbers, the SMS you must send is:
Example: !IDAS#1234#12345678#
AutoSat replies: New ID:12345678
3
.2. SMS remote command with only SMS replay
To change Password (command "!PASS")
NOTE The password may be alphanumerical and have 8
1234
AutoSat is factory supplied with PSW
It is possible to change the access password of the AutoSat by sending an SMS command
message with the following format:
!PASS#PSW#new_password#
Example: !PASS#1234#abcd1278#
AutoSat replies: New password: abcd1278
AutoSat GPS - GPRS video instruction manual
ENGLISH
r
r
#
1
2
3
r
= 3 for 160x128 pixels
i
r
= 7 for 640x480 pixels
i
characters.
.
Page 7