AUTOSCALER AW30C Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Konverter Media AUTOSCALER AW30C. AUTOSCALER AW30C 14 halaman.

Halaman Cetak

Connect the AC POWER CORD to supply. GROUND conductor MUST BE

Used.

Connect Handpiece leads, and Power Control pot leads according to

drawing FRONT VIEW. There is NO POLARITY for Handpiece leads or

Power Control Pot leads. IT IS SUGGESTED THE 15' EXTENSION WIRES

(not supplied) CONNECTED TO THE AUTOSCALER® CONSOLE BE

SOLDERED TOGETHER, AND INSULATED WITH A "UL or CSA"

APPROVED SHRINK TUBING Hand twisting and taping of wire

connections is NOT recommended. It may affect the performance and

safety of the installation.

When installing the AUTOSCALER® build-in unit, the AIR SOURCE used

to activate the scaler MUST be independent of all other operatory

equipment, and the supply line pressure must relieve to ZERO PSI after

each activation. The AUTOSCALER® unit may be damaged by activation

while other equipment is in use if the air signal is not turned OFF to

the scaler, and line pressure fully relieved when not in use.

The AUTOSCALER® is internally fitted from the factory with a pressure

relief valve (restrictor) and must not be removed. This restrictor helps

relieve line pressure after each activation.

IMPORTANT: The AUTOSCALER® unit has been calibrated

anticipating approximately 15' Fifteen feet of 18 GAUGE wire will be

used in the installation. DO NOT use any wire thinner than 18 GAUGE.

This will change the tuning (i.e. insert will not vibrate properly) of the

AUTOSCALER® and/or not function.

ULTRASONIC SCALER INSERTS

DIRECTIONS FOR USE FOR OPTIMAL FUNCTION.



Sterilize before each use in accordance with the insert

manufacturer's instructions



Federal Law restricts the device to sale by or on the order of a

licensed practitioner



3 month warranty

INSERT DEVICE DESCRIPTION

Ultrasonic inserts are accessory inserts designed for use with

magnetostrictive scaler units, (see specifications) that generate a

frequency of either 25KHz or 30KHz. A range of tip designs are available to

suit different clinical conditions. Finger-grips are either plastic or metal

and the water channel is either of internal or external design. These

inserts are designed to be used in magnetostrictive ultrasonic scalers only

by professionally trained operators, such as Dentists or Dental Hygienists,

to perform general supra and subgingival scaling procedures.

Internal water channel with plastic finger-grip

Tip Design

DF#3 Beaver Tail/Flat

Heavy to moderate supragingival deposits

on buccal and lingual surfaces.

DF#10 Universal Curette

Heavy to moderate supragingival deposits,

light to moderate subgingival deposit on all

surfaces.

DF#100 Periodontal Style

Light to moderate supragingival deposits

especially interproximally.

External water channel with metal finger-grip