Highlander MAGNOPHONIC Manual - Halaman 4
Jelajahi secara online atau unduh pdf Manual untuk Penguat Alat Musik Highlander MAGNOPHONIC. Highlander MAGNOPHONIC 4 halaman. Pickup and preamp for the tricone resophonic guitar
Halaman Cetak
Plug in the Pickup and Slip on the Clip
Plug in the Pickup and Slip on the Clip
8
Plug in the RCA Jack
a
8
Velcro
Cable
®
b
CHECK THE GAP
CHECK THE GAP
UNDER STRING TENSION
UNDER STRING TENSION
MEASURE
MEASURE
THE GAP
THE GAP
Pickup
Last but not Least:
Last but not Least:
If the portion of strings between
the tailpiece and the saddle is
free to resonate, harmonics that
normally cannot be heard are
amplified and made audible.
T h i s c a n b e p r e v e n t e d b y
damping the area with a piece of
d e n s e f e l t o r l e a t h e r, w o v e n
through the strings.
Pickup secured
Pickup secured
to the mounting
to the mounting
stud on the pan.
stud on the pan.
There must be a gap between the T-Clip and the Pickup for the system to operate correctly
T-Clip
operty of Highlander Musical Audio Products. Copying of any kind is prohibited, except for personal use only.
The T-Clip and Pickup use magnetic principles that are similar to dynamic
microphones, using the structure of the Tricone to create a virtual microphone
Install the T-Clip by locating it at narrow part
of the T-Bridge and pushing it back so that it
is positioned above the center of the pickup.
Tip: Place the cones in the pan, locate the T-Bridge on the cones
and mark the center of the pickup on the side of the T-Bridge
with a pencil. Use the pencil mark to line up the T-Clip.
UNDER STRING TENSION:
UNDER STRING TENSION:
Measure the Gap between the bottom of the T-Clip
and the top of the Pickup.
The Gap must be between 1/16" and 3/32"
(1.5mm / 2.4mm).
The T-Clip must not rest on or touch the Pickup.
If the GAP is too Small:
Check between the pan and the neck stick for any wooden shims. Removing or
reducing the thickness of any shims will lower the pan and increase the GAP.
It may also help to remove a small amount of material from the underside of the T-
Bridge at the point where the T-Clip is located. This should be limited to 1/32" (0.8mm).
For clarity the tailpiece
For clarity the tailpiece
and strings are not shown
and strings are not shown
9
Install the T-Clip
T-Clip
in place
©
Highlander Musical Audio Products 1991-2009
Saddle
T-Bridge