GALLERY 60 Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Industri GALLERY 60. GALLERY 60 18 halaman. Canvas stretching machine

Position the frame so that it is against the "mechanical stops", a short tab of metal about

1/8" high (these stops also facilitate alignment during the stretch). Loosen the (4) screws

on each of the slotted stretcher plates.

Apply air to your machine and depress the foot pedal to open the clamping bar. Move the

assembled frame and the plates together in and out until the face of the wooden frame is

approximately ½-

" behind the angle bar. In other words, create a gap so the canvas

5/8

would "waterfall" down into the opening when the foot pedal is depressed. This step is

simulated without the canvas present.

Tighten all of the screws. This setting would then be good for any stretcher bar for this

width. This procedure would only need to be done again when a different width of

stretcher bar is to be used.

This is referred to as the "Loaded Position"