DCS DCS-VH-36 Panduan Penggunaan dan Instalasi - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Instalasi untuk Kap Ventilasi DCS DCS-VH-36. DCS DCS-VH-36 18 halaman. The professional vent hoods
Halaman Cetak
SITE PREPARATION:
In
cases
where
the
installation
site
does
not
have a soffit
structure,
theVent
Hood assembly may be
secured directly to the wall from the rear of the unit.
NOTE-
When installing the vent hood directly to the rear walt, an adequate structural walt support (studs)
must exist to secure the unit.
NOTE-
The DCS Duct Cover should be orderedand installed when installing the vent hood in a site without a
soffit. DCS offers both a 6"and 12"height Duct Covers. Keep the 6 or 12 inch dimension in mind when allow-
ing for clearance between the top of the Vent Hood and the ceiling. (see Fig.4)
I. With theVent Hood width, and installation site in mind, marl( the centerline of the installation.
2. See the chart in Fig.4 to determine the centerline to centerline dimension of wall mounting holes
for the particular model being installed.
3. Cut away enough drywall (if installed) to expose 2 vertical studs (I on each side of the Hood
center line) It will be necessary to A) construct
a plywood wall insert (See Fig 5) or B) install
aligning wall studs. (See Fig 6).
WALL
MOUNTING:
After an adequate wall structure
has been completed, secure the DCS Duct Cover (6" or 12") to the
top of the vent hood.
Carefully lift the hood with the duct cover into the installation site and secure
the hood into the wall structure with 6 (six) mounting screws. Once the Hood assembly has been
secured to the wall, the front of the Soffit Chimney may be removed for ductwork
connections.
-GOTO
FINISHING THE INSTALLATION
Pg.9
(.
i ir
Plywood
Sheet
(wall hole
cut out
x drywall
thickness")
/
ne of
installation
space.
Additional
Wall Studs
Installed
r/
d