DCS EH-36SS Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kap Ventilasi DCS EH-36SS. DCS EH-36SS 14 halaman. The professional euro vent hood
Juga untuk DCS EH-36SS: Panduan Penggunaan dan Instalasi (18 halaman), Panduan Penggunaan dan Perawatan (11 halaman), Panduan Penggunaan dan Perawatan (7 halaman), Panduan Instalasi (16 halaman)

Halaman Cetak
DCS EH-36SS Panduan Instalasi
CALCULATE THE DUCT RUN LENGTH
The duct run should not exceed 35 feet for ducted six inch (6") round ductwork. Calculate the length
of the ductwork by adding the equivalent feet in Fig. 08 for each piece of duct in the system. An
example is given in Fig. 09. For best results, use no more than three 900 elbows. Make sure that there
is a minimum of 24" of straight duct between elbows if more than one is used. Do not install two
elbows together.
45° Elbow
90° Elbow
90° Flat Elbow
Wall Cap
FIG.08
WARNING
Due to personal injury hazard because of the weight and size of the Euro Hood
canopy, two or more people are needed to move and safely install the Euro
Hood canopy. Failure to properly lift Euro Hood could result in damage to the
product or personal injury.

WALL PREPARATION

WARNING:
The screws provided for mounting this Euro Hood must be inserted into solid
wood. These must not be inserted into sheet rock.
1) Disconnect and move freestanding range from cabinet opening to provide easier access to
upper cabinet and rear wall. Put a thick, protective covering over cooktop, set-in range or
countertop to protect from damage or dirt.
2) Determine and clearly mark with a pencil the centerline on the wall where the Euro Hood will
be installed.
3) The Euro Hood attaches to the wall by mounting screws. For the 30" and 36" models, there are
two mounting screws. Install the screws into the wall. The screws should be inserted into the
wall until the screw head is flush with the wall.
4) The optional chimney kit is adjustable and designed to meet varying ceiling heights. The
chimney attaches to the wall by two additional brackets. The top bracket should be installed
about 1/8" away from the ceiling. The middle bracket must be installed at the bottom point of
the upper chimney sleeve. Determine the proper location for each bracket and install the
brackets on the wall. Attach the bottom of the lower chimney to the canopy using the screws
provided.
CAUTION
Make sure that the screws and brackets are securely fastened to the wall.
INSTALLATION INSTRUCTIONS
5.0 feet
7.0 feet
12.0 feet
0.0 feet
:
:
8
9 Feet Straight Duct
9.0 feet
2 - 90° Elbows
14.0 feet
Wall Cap
0.0 feet
Total System
23.0 feet
FIG.09