GALLERY GS-60 Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sistem Pembungkus Peregangan GALLERY GS-60. GALLERY GS-60 17 halaman.

Universal Mount Installation (Optional Equipment)

(Detailed Instructions & Video)

The universal bench mount consists of (1) pair of brackets for a 60" machine and (2) pair

of brackets for a 96" machine. The brackets are paired so that there is a left-hand and

right-hand bracket, (refer to photo at bottom of page) indicated by the small tab on each

bracket that favors one side as viewed from the front.

Installation for 60":

Locate the centerline of the bench and make a mark. Place the left-hand bracket

(identified by the forward most tab on the left outside edge) where the outside edge of the

top mounting plate is 21.125" to the left of the centerline and secure it to the bench using

the 2 holes at top of the mount. There are (3) additional holes on the face of the mount if

you do not want to drill on top of your bench.

Place the right hand bracket 21.125" to the

right of the centerline. Please confirm that the distance between the 2 small tabs in the

front are 39" apart inside to inside. These tabs will "trap" the machine to reduce

movement. Your mounts come with (2) metal ¼-20 screws that allow you to apply just a

little pressure. (pictured below)

42.25"

for 60"

Left bracket

tab outside

Right bracket

tab outside

Metal screws