COPLAR LTA-LG-01 Panduan Operator - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pemangkas COPLAR LTA-LG-01. COPLAR LTA-LG-01 11 halaman. Line trimmer attachment

PERATION

OPERATING THE TRIMMER See Figure 4.

Hold the trimmer with the right hand on the rear handle and the left hand on the front handle. Keep a

firm grip with both hands while in operation. Trimmer should be held at a comfortable position with the

rear handle about hip height.

Cut tall grass from the top down. This will prevent grass from wrapping around the shaft and string head,

which may cause damage from overheating. If grass becomes wrapped around the string head, stop the

engine, remove the spark plug wire or disconnect from the power supply, and remove the grass.

NOTE: When the attachment is being used on a trimmer with a gasoline engine, always operate at full

throttle. Prolonged cutting at partial throttle will result in oil dripping from the muffler.

ADVANCING THE STRING

ADVANCING STRING USING THE LINE TAP ADVANCE SYSTEM

String advance is controlled by tapping string head on grass while running engine at full throttle.

1 Run engine at full throttle.

2 Tap string head on ground to advance string. String advances each time the head is tapped.

3 Several taps may be required until string strikes the cut off blade.

4 Resume trimming.

NOTE: If the string is worn too short you short you may not be able to advance the string by tapping it

on the ground. If so, stop the engine, remove the spark plug wire or disconnect from the power supply,

and manually advance the string.

ADVANCING THE STRING MANUALLY

Push the spool retainer down while pulling on string(s) to manually advance the string.

CUTTING TIPS

See Figure 5.

1. Keep the trimmer tilted toward the area being cut; this is the best cutting area.

2. Do not cut in dangerous cutting area.

3. Use the tip of string to do the cutting; do not force string head into uncut grass.

4. Wire and picket fences cause extra string wear, even breakage. Stone and brick walls, curbs, and wood may

wear string rapidly.

5. Avoid trees and shrubs. Tree bark , wood moldings, siding, and fence posts can easily be damaged by the string.

GRASS DEFLECTOR LINE TRIMMING CUT-OFF BLADE

See Figure 6.

This trimmer is equipped with a line trimming cut-off blade on the grass deflector. For best cutting,

advance string until it is trimmed to length by the cut-off blade. Advance string whenever you hear the

engine running faster than normal. This will maintain best performance and keep string long enough to

advance properly.

- 9 -