Dynaudio Sub 6 Panduan Pemilik - Halaman 17
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pembicara Dynaudio Sub 6. Dynaudio Sub 6 20 halaman.
Halaman Cetak
Sub 6 Troubleshooting Matrix
Problem
Cause
The subwoofer switches itself off
There is hardly any low-frequency signal
although music is playing.
available. This can happen if the music
or movie itself does not contain very low
frequencies (e.g. long dialogues).
The subwoofer will not switch on.
• AC mains cable has become
disconnected.
• Mains switch on the rear is switched
to OFF.
The subwoofer will not switch on
• No signal is present on either of the
automatically.
subwoofer's inputs (LED lights red).
Subwoofer is switched on not making
• No signal is present on either of the
any sound.
subwoofer inputs.
• In the processor or receiver's bass-
management set-up, subwoofer has
been disabled.
• Subwoofer volume level has been
turned down on the processor/
receiver.
• Volume is turned down on the
subwoofer controls.
32
Solution
• The subwoofer will switch on
automatically as soon as low
frequency signals are detected.
Make sure to switch the system
off first before making any
changes!
• Reconnect mains cable.
• Switch mains back on.
• Check if all signal cables are
connected properly.
Make sure to switch the system
off first before making any
changes!
• Check if all signal cables are
connected properly.
• Check if the subwoofer output on the
source is active.
Make sure to switch the system
off first before making any
changes!
• Check if all signal cables are
connected properly.
• Check settings in Bass Management
menu of the connected amplifier or
receiver.
• Carefully and gradually increase
the subwoofer volume level on the
amplifier or receiver.
• Carefully and gradually increase
the subwoofer volume level on the
subwoofer GAIN control.
Sub 6 Specification
Data
Sub 6
System
Twin opposed driver, closed box, active DSP subwoofer
Analog inputs
2x balanced XLR, 2x unbalanced RCA phono
Max. input voltage
1.01Vrms @ +6dB Sensitivity, 2.0Vrms @ 0dB Sensitivity
4Vrms @ -6dB Sensitivity, 10.1Vrms @ -14dB (LFE) Sensitivity
Analog outputs
2x balanced XLR, 2x unbalanced RCA phono
XLR output impedance
Differential: 200Ω, Single-ended: 100Ω
Phono output impedance
100Ω
XLR Pin-out
Pin 1: ground, Pin 2: signal +, Pin 3: Signal –
Frequency response
16Hz–230Hz ±3dB
Auto ON/OFF
Yes
Box Principle
Sealed
Low Pass Filter
Adjustable/preset
Phase Adjustment
0/180 degrees
Woofer
2x24cm MSP+ Hybrid Drive
Amplifier power
500W
AC power input
100-120V/220-240V 50/60Hz
Standby power consumption
<0.5W
Maximum power consumption
490W
Weight
21.5kg/45.2lb
Dimensions (WxHxD)
447x300x268mm/17.6x11.8x10.6in
Dimensions with feet/grill (WxHxD)
470x333x268mm/18.5x13.1x10.6in
Configuration and Use
33