Highly Components HC-61 Panduan Instalasi
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Lampu luar ruangan Highly Components HC-61. Highly Components HC-61 2 halaman. Infrared led sensor lamp
Halaman CetakHC-61
Installation Manual
Welcome to use HC-61 Infrared LED Sensor Lamp!
The product is an energy-saving automatic sensor lamp, adopting integrated circuit and precise
detecting components. It gathers automatism, convenience, safety, saving-energy and practical
functions. Its performance is stable. It can identify day and night. The lamp can turn on when one
enters detection field and can turn off automatically when one leaves detection field.
SPECIFICATION:
Power Source: 220-240V/AC
Power Frequency: 50/60Hz
Ambient Light: <3-2000LUX (adjustable)
Time Delay: Min.10sec±3sec
Max.15min±2min
Rated Load: 30W (2200LM)
Additional switching capacity: 500W
Detection Range: 240°
Detection Distance: 5-10m(<24℃)adjustable
Working Temperature: -20~+40℃
Working Humidity: <93%RH
Installation Height: 1.8-2.5m
Detection Moving Speed: 0.6-1.5m/s
IP Class: IP65
FUNCTION:
Can identify day and night: The consumer can adjust working state in different ambient light.
It can work in the daytime and at night when it is adjusted on the "sun" position (max). It can
work in the ambient light less than 3LUX when it is adjusted on the "3" position (min). As for
the adjustment pattern, please refer to the testing pattern.
SENS adjustable: It can be adjusted according to using location. The detection distance of
low sensitivity could be only 5m and high sensitivity could be 10m which fits for large room.
Time-Delay is added continually: When it receives the second induction signals within the
first induction, it will restart to time from the moment.
Adjustable Time Delay: the length of time delay could be set according to the customers'
requirement, the minimum time of this item is 10sec ± 3sec, the maximum is 15min±2min.
Good sensitivity
INSTALLATION:
Switch off the power.
Screw off the nail on the bottom of sensor lamp and
unload the bottom. Open the wire hole in the
bottom and pass the wire through the hole.
Fix the bottom on the selected position with the inflated screw.
Connect the power wire into connection-wire column according to the connection-wire
diagram.
Fix back the sensor lamp on the bottom. Switch on the power and then you can test it.
It not only can install on the wall directly but also can install in the outer corner with the
help of the widget (refer to photograph below):
The LED can tilt up/down, turn left/right according to
the customers' requirement as the right drawing:
Poor sensitivity
Flat mounted
Outer corner mounted