Dynaudio 18S Petunjuk Manual - Halaman 10
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Subwoofer Dynaudio 18S. Dynaudio 18S 15 halaman. Active dsp subwoofer
Halaman Cetak
Mains and signal connections
The 18S is fitted on its rear face with a
2. Balanced XLR input sockets
connection and control panel carrying
(left and right). If your monitoring
mains, signal and conne ction sockets.
hardware provides balanced outputs
The panel is illustrated in Diagram 3 and
connect them to these sockets using
its connection facilities are described in
high quality balanced XLR audio
the following paragraphs.
cables.
1. Mains power socket. Connect the
subwoofer to a mains power supply
Note
using the cable supplied. If multiple
Balanced signal connection is a
cables are supplied with your
feature of professional audio and
subwoofer, use the one appropriate
of some high-end domestic audio
for your territory.
equipment. It is inherently more
resistant to interference and noise
than unbalanced connection.
Note
Do not switch on your subwoofer
until all other connections have
3. Balanced XLR output sockets
been made.
(left and right). The XLR output
sockets are intended for the
connection of active left and right
monitors or for a power amplifier
driving passive monitors.
Note
The 18S distance compensation
signal processing can only
function correctly if the monitors
are driven via the subwoofer
outputs.
18
4. Unbalanced phono input sockets
(left and right). If your monitoring
hardware provides unbalanced
phono outputs connect them to
these sockets using high quality
phono audio cables.
Note
If your audio source provides only
a mono subwoofer output it can
be connected to either 18S phono
input. In this case however the
main speakers must be driven
from the audio source and not via
the 18S outputs.
5. Unbalanced phono output
sockets (left and right). The phono
output sockets are intended for the
connection of active left and right
monitors or for a power amplifier
driving passive monitors.
Note
The 18S distance compensation
signal processing can only
function correctly if the monitors
are driven via the subwoofer
outputs.
Subwoofer connections
6. Trigger input. The trigger input
enables wired remote control of
subwoofer standby and operational
modes in automated systems. Your
Dynaudio retailer or installer will be
able to provide more information
Service
on the use of the 18S in home
automation systems.
Auto
ON/OFF
Note
The USB socket present on the
18S connection panel is intended
for fault diagnosis and firmware
update only. It cannot be used
for audio connection or playback.
Contact your Dynaudio retailer
or Dynaudio directly for more
information of firmware updates.
Trigger
Right
Right
Left
Left
in
out
in
out
in
6
Max. 12 V DC
5
4
5
4
Right
Left
in
in
2
3
1
Right
Left
out
out
100-120 V~, 200-240 V~
50/60 Hz 490 W
Installation
19