AGROPLAST P-100 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pompa Air AGROPLAST P-100. AGROPLAST P-100 8 halaman.

Technical data:

efficiency

min rev

max rev

engine oil

oil amount

weight

height

width

CHARACTERISTICS OF THE P-100 PUMP:

the use of needle bearing on rotating elements contributes to the prolonged and failure-free pump

running and the decrease of the heat production to the minimum

aluminum piston working in the iron bushing ensures the best cooperative properties of these ele-

ments

small amount of exuded heat allows for a long constant pump usage

USE:

Membrane-pressure pump is intended for use in field spraying machines It may be used with legalized

plant protection agents and liquid mineral fertilizer

FIRST START-UP:

After pump installation on the spraying machine, trial start-up is necessary as well as check-up and the

potential adjustment:

the level of oil visible in the observation glass should not be lower than its half or its marked mini-

mum,

a potential deficiency should be supplemented with CB SAE 40 oil or engine oil of similar parameters

check the pressure in the pump's air vessel with the use of a manometer connected to the air valve The

pressure in the air vessel of a stagnant pump should equal 1/3 to 1/2 of its working pressure Drain or

pump up air with the use of a compressor or automotive pump complete with a manometer

SERVICING AND THE CONDITIONS OF SAFE USAGE:

In order to ensure long term and failure-free running of the pump:

every time before start-up check and potentially adjust the oil level in the pump and the pressure

of the pressure manifold air vessel in accordance with prior instructions included in this manual,

every time after finishing work rinse the pressure system with water,

after the termination of the exploitative season and during the period of frost in early spring, au-

tumn and winter, drain the remainder water from the manifold (remove the suction cord of the

pump and use it for several seconds (15-20), in order to remove all the water from the inside,

control the wear of the pressure cables – replace them in case of their rupture or tear

check the durability of the elbow pipe connections supplying and draining the liquid to and from

the pump

SERVICING AND THE CONDITIONS OF SAFE USAGE 5

100 l/min

350 rev/min

550 rev/min

CB SAE 40

0,65 L

10,13 kg

320 mm