HighPoint SSD7505 Menggunakan Manual - Halaman 9

Jelajahi secara online atau unduh pdf Menggunakan Manual untuk Pengontrol HighPoint SSD7505. HighPoint SSD7505 19 halaman. Using nvme raid aics with the dell precision 3930 rack workstation
Juga untuk HighPoint SSD7505: Panduan Instalasi (14 halaman), Panduan Instalasi (12 halaman), Panduan Instalasi (15 halaman), Panduan Instalasi Cepat (6 halaman), Panduan Instalasi Cepat (8 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (19 halaman)

Using HighPoint NVMe RAID AICs with the Dell Precision 3930 Rack Workstation

3. Installing HighPoint NVMe RAID AIC into Dell Precision 3930

Rack Workstation

a. Screwdriver (system cover require a screwdriver to open)

b. Wired ESD wrist strap (to prevent electrostatic accidents)

a. Use a wired ESD wrist strap that is properly grounded.

b. Shut down the system.

c. Insert a screwdriver and turn counterclockwise to unlock the system cover

latch.

d. Lift the latch upward to remove the system cover.

e. Remove the riser1 module from the system.

f. Pull the riser1 module latch and remove the riser1 module filler bracket.

g. Holding the edge of the HighPoint NVMe RAID AIC, align the HighPoint NVMe

RAID AIC connector with the riser1 module slot and insert it downward.

h. If you are using the SSD7140A, SSD7540, RocketAIC 7140AW, or RocketAIC

7540HW, you will need to connect the power cable to the 8-pin power

connector on the system and to the 6-pin power connector on the side of the

HighPoint NVMe RAID AIC.

Notes:

If you are not using the SSD7140A, SSD7540, RocketAIC 7140AW, or

RocketAIC 7540HW, you can safely move to the next step.

You may need to purchase additional power cables.