adeptus 88040 Manual Petunjuk Perakitan - Halaman 5

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Gerobak Luar Ruangan adeptus 88040. adeptus 88040 10 halaman. 4 + 1 drawer euro roll cart

Halaman Cetak

ATTACH THE SIDES TO THE CROSSBARS

ATTACH ONE SIDE FIRST AND THEN THE OTHER.

• DO NOT STAND LEFT SIDE (PART 3) UP

ON THE EDGE YET. TO EASE ASSEMBLY,

LAY SIDE FLAT ON THE FLOOR, RUNNER

SIDE VISIBLE.

• MATCH UP BACK CASTER SUPPORT (PART 6)

AND FRONT CASTER SUPPORT (PART 5) AT DOWEL

HOLES LOCATED AT THE BOTTOM OF SIDE.

• PLEASE CHECK THAT THE DISTANCES

MATCH TO THE SQUARE DIAGRAM. EACH CASTER SUPPORT

SHOULD BE FLUSH WITH FRONT AND BACK EDGES OF SIDES.

• SECURE BACK CASTER SUPPORT (PART 6) TO THE LEFT

SIDE (PART 3) USING SCREW (PART C).

SEE THE ROUND DIAGRAM, A BLOW UP IMAGE OF THE SCREW

POSITIONING THOUGH THE ANGLED POCKET HOLES.

• SECURE FRONT CASTER SUPPORT (PART 5) WITH SCREWS

(PART C) TO THE LEFT SIDE (PART 3) IN THE SAME MANNER.

• CAREFULLY TURN LEFT SIDE (PART 3) TO ITS BACK EDGE,

AS SHOWN IN THE DIAGRAM.

• POSITION RIGHT SIDE (PART 2) TO LINE UP THE CROSSBARS

(PART 5 AND 6) AT THE DOWEL HOLES AT BASE OF THE RIGHT

SIDE (PART 2).

• SECURE CASTER SUPPORTS (PART 5 AND 6) TO RIGHT SIDE

(PART 2) USING SCREW (PART C) AND SHOWN IN THE DIAGRAM.

TIP: HAND TIGHTEN FOR THE BEST FIT.

ATTACH THE TOP

• LINE UP THE DOWEL HOLES IN TOP (PART 1)

WITH DOWELS THE IN UNIT'S SIDES.

SEE ROUND DIAGRAM:

SLIDE (PART C) SCREWS THROUGH ANGLED

POCKET HOLES.

AND HAND TIGHTEN FOR BEST FIT.

C=06

Screw

3.5 x 30mm

NOTICE: THE WRITTEN INSTRUCTIONS CONTAINED HEREIN COPYRIGHTED.

TIP: This step is

easier with

two people.

C=04

Screw

3.5 x 30mm

5-10