Gallien-Krueger Microbass MB150E Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Gallien-Krueger Microbass MB150E. Gallien-Krueger Microbass MB150E 12 halaman. Iii series
Juga untuk Gallien-Krueger Microbass MB150E: Panduan Pemilik (12 halaman)

Halaman Cetak

Gallien-Krueger Microbass MB150E Panduan Pemilik

Rear Panel Controls

1 Power On/Off Switch: Press in to turn the amplifier

on, out to turn it off. Power/Protect LED is on when the

amplifier is on.

2 AC Receptacle: The power cord is detachable and

plugs in here.

3 Speaker Output: Power amp ¼" jack outputs. It

delivers 150W into 4 Ohms or 100W into 8 Ohms.

4 Internal Speaker On/Off Switch (Combo Only):

Turns the internal speaker off for private headphone lis-

tening or to allow the internal power amplifier to drive an

external speaker load of 4 ohms.

5 Effects Return Jack (MBE Only): When the Re-

turn jack is used, the Effects Loop is in series. All of the

signal goes through the Effects Loop.

6 Effects Send Jack (MBE Only): Send and return

jacks provided for the insertion of effects after the EQ,

but before the boost section.

7 Footswitch Jack (MBE Only): Use the RF2

Footswitch to turn on/off the Boost and Chorus effects.

8 Direct Outputs (MBE Only): A pair of electroni-

cally balanced low Z outputs, for sending a separate left

and right mic level signal to a PA system. Pre/Post Swit-

chable.

9 Ground/Lift (MBE Only): This switch discon-

nects the ground on the balanced, XLR output to elimi-

nate hum and buzz when connecting to equipment that

is on a different ground system.

10 Direct Out Mode Switch (MBE Only): When

Mode 1 is selected, XLR Right is Mono Post and XLR

Left is Mono Pre. When Mode 2 is selected, the Direct

Outs are Post Left/Right for Stereo Chorus output.

11 Line Out: Provides a line level signal (post Boost)

for interfacing with outboard power amplifiers or an ex-

ternal DI Box.

MicroBass-III Series

3 5

Internal/External Speakers

The MB-III Series combos feature one 8 Ohm, 12"

low resonance speaker, which delivers surprising low-

end response and volume for it's size. While it works

great for electric bass, the MB Series combo is par-

ticularly well suited for acoustic upright bass.

Driving External Cabinets:

The MB Series combo electronics are identical to the

MB Series heads and are rated for the same maximum

power output and speaker load (150W into 4 Ohms

or 100W into 8 Ohms). Maximum power is achieved

by connecting one 8 Ohm extension cabinet such as

the 112MBX in addition to the combo's internal 8 Ohm

speaker load. To drive more than one extension cabi-

net, the combo's internal speaker can be disconnected

by pressing the Internal Speaker switch on the back

panel. Below is a detailed description of the maxi-

mum loads the combos can drive.

Maximum Recommended Load:

Internal Speaker On:

One 8 Ohm extension cabinet.

Internal Speaker Off:

One 4 Ohm, or Two 8 Ohm extension cabinets.

4 6

3 7

9 10 11