HIGHSIDER EVO Petunjuk Pemasangan - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan untuk Aksesori Sepeda Motor HIGHSIDER EVO. HIGHSIDER EVO 2 halaman. Handle bar end

HIGHSIDER™ handle bar end „EVO"

Mounting Instructions

This HIGHSIDER™ "EVO" handle bar end can be used as an universal bar end or as a

mounting kit for our HIGHSIDER bar end mirrors.

The "EVO" bar end fit on most common handle bars with an inner diameter of 12 mm to

21 mm (that mean most Aluminium and steel handle bars with an outer diameter of 7/8"

(22 mm) to 1" (25,4 mm).

Scope of delivery:

2 x Aluminium handle bar ends (C)

Each 2 x clamp sleeves (E1) + (E2)

Each 2 x centering sleeves (K1), (K2), (K3)

Each 2 x central screw M6 (F), tooth washer (G) and conus-nut (H)

Read this manual carefully and store it.

Step 1:

Unpack the bar ends and check the contents for completeness.

Step 2:

Choose the correct clamp sleeve (E1) (E2) and centering sleeve (K1) (K2) (K3) for your

handle bar.

1. Inner handle bar diameters from 12 mm to max. 13,9 mm: Use sleeve (E1).

2. Inner handle bar diameters from 14 mm to max. 15,9 mm: Use sleeve (E1)+(K1).

3. Inner handle bar diameters from 16 mm to max. 17,9 mm: Use sleeve (E1)+(E2).

4. Inner handle bar diameters from 18 mm to max. 20,9 mm: Use sleeve (E1)+(E2)+(K2).

5. Inner handle bar diameter 21 mm: Use sleeve (E1)+(E2)+(K3).

Step 3:

Assemble the clamp sleeves (E1) (E2) and where necessary the suitable centering sleeve

(K1) (K2) (K3) on central screw (F) according to pic. 1+2.

Important: the tooth washer (G) must be placed between the handle bar ends (C) and the

sleeves (E1) (E2).

Pre-tension the clamp sleeve by turning the Allen screw (F), until the sleeve fit smoothly into

the bar end. If needed, hold the conus-nut (H) with a multigrip pliers. The handle bar end (C)

should lie flat on the handle bar tube.

Warning: Make sure that the throttle tube don't get jammed and can still turn freely!

Tighten the Allen screw (F).

07/2014 • #161-032A

Important notice for optional mirror mounting:

• Attach the mirror arm on the bar end in the desired position, as close to the tube end

as possible.

• Make sure that the throttle tube on the right side may always turn back freely!

A jammed throttle tube can cause bad accidents!

• Adjust the mirror head to guarantee the best view to the rear.

• Please pay attention that the mirror does not impact any parts (e.g. fuel tank) if turning

the handle bar.

• Before each ride, make sure that all parts are fixed well.

• Damaged mirrors or parts must be replaced immediately.

• Clean your mirror and bar end only with soft cloth and only use suitable soft cleaner.