Gallo Tech GTS-3RS Panduan Pengoperasian & Pemasangan - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengoperasian & Pemasangan untuk Alarm Mobil Gallo Tech GTS-3RS. Gallo Tech GTS-3RS 16 halaman. Keyless rfid push button start & security system
Halaman CetakPositive trigger door lock systems send a Positive (+12V) pulse to existing factory relays to lock and unlock
the vehicle doors.
Electric vacuum pump: Pre-'95 Mercedes-Benz and Audi (Figure 5 page 14)
Reverse Polarity: Many Ford/Lincoln/Mercury/Dodge/Chrysler/Plymouth and early 90's GM Trucks
(Figure 6 page 14)
The door lock/unlock motors are controlled directly from the lock and unlock switches in the door. The lock
and unlock wires rest at Negative Ground when not in use. When the lock or unlock button is pressed, one of
the circuits is "Lifted" and replaced with +12V causing a lock or unlock to occur.
Single Wire (Dual Voltage): Late model Chrysler/Dodge/Plymouth Vehicles, some year 2000 and newer
GM vehicles (not shown)
Dual Voltage systems have lock/unlock switches that send varying levels of Positive voltage OR Negative
ground current to the SAME wire for both lock and unlock. When the vehicle's Body Computer Module (BCM)
or door lock module senses different voltages on this wire, the system will either lock or unlock. Single wire
door lock systems require relays and resistors. This type system requires that you have a good working
knowledge of their operation before attempting installation of GTS-3RS.
Data bus Systems 2003 and newer. (not shown)
Data bus systems send low current "Data messages" to the door lock controllers in order to lock and unlock
the vehicle. To install aftermarket systems in these vehicles, an interface module can be used to convert the
regular lock/unlock pulses into "Data messages". This type system requires that you have a good working
knowledge of their operation before attempting installation of GTS-3RS
1.2 KEY FOB OPERATION:
When approaching the vehicle with the RFID FOB in the pocket or purse, the presence of the RFID FOB will be
recognized by the control module. The doors will then unlock and the vehicle will be ready to start using the "Start
Stop Engine" button. The green LED on the "Start Stop Engine" button will flash. An ignition key is not required.
After turning the engine OFF using the "Start Stop Engine" button and the driver leaves the vehicle with the RFID
FOB in his/her pocket/purse, the accessories will turn OFF (equivalent to turning the key off) the doors will lock and
the ARMED mode will be activated. The Red LED on the "Start Stop Engine" button will flash continuously while in
the armed mode. The small LED on the key FOB will flash green when the FOB is within detection range of the
vehicle. When the small LED flashes red, the key FOB battery should be replaced. The four buttons on the RFID
FOB can be used to activate/deactivate other functions:
(Lock Button): Arm/Remote- Lock/Panic/Siren-Stop
a.) Arms the system and locks the doors with one press
Siren will chirp 1X and parking lights flash 1X, doors will lock. The Red LED on the "Start Stop
Engine" button will flash slowly.
Shock Sensor will become active after 15 sec.
The alarm will chirp and parking lights will flash 3X if all the doors are not closed during arming.
If the alarm siren has been triggered, pressing this button one time will silence the siren and keep the
system in the armed mode.
b.) Panic:
Holding this button for over 2 seconds will cause the siren to sound for 10 seconds and the system
will remain in the armed mode.
c.) Lock only (when vehicle occupied)
When the ignition is ON, and the system is disarmed, pressing this button will lock the doors. The
system will stay in the disarmed mode.
NOTE: Siren chirp off/on is user programmable. See Table 1 option #5 page 9.
.
(Unlock Button): Disarm/Remote-Unlock/Trunk release.
a.) Disarm the system and unlock the doors with one press
Siren will chirp twice and the parking lights will flash twice. The doors will unlock and the system will
be in the disarmed mode.
Within 5 seconds after pressing the
system will automatically rearm and relock the doors.
© Copyright Gallo Technologies. All Right Reserved
button, if a door is not opened or the ignition is not ON, the
- 3 -
061515V54RS