Galls Street Thunder ST280 Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 17
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Penguat Galls Street Thunder ST280. Galls Street Thunder ST280 18 halaman. Siren amplifier & light controller
Juga untuk Galls Street Thunder ST280: Panduan Petunjuk Pemasangan dan Pengoperasian (20 halaman)
Halaman Cetak
Input Voltage
Input Current
Standby Current
Audio Frequency
Audio Output
Output Power
Siren Frequency
High Voltage Protection
Short Circuit Current
Operating Temperature
Siren Controls
Diagnostic Indicators
Light Controls
Light Output Ratings
Siren Connections
(12-Pin Connector)
Light Control Connections
Size
Shipping Weight
Galls warrants this new product to be free from defects in material and workmanship, under
normal use and service, for a period of seven (7) years from the date of delivery to the first
user-purchaser.
During this warranty period the obligation of Galls is limited to repairing or replacing, as
Galls may elect, any part or parts of such product which after examination by the
manufacturer is determined to be defective in material and/or workmanship.
This warranty does not cover labor charges for removal or re-installation of the product.
Fuses and lamps are not covered under this warranty.
This warranty does not extend to any unit that has been subjected to abuse, misuse, improper
installation or which has not been adequately maintained, nor to units which have problems
related to service or modification at any facility other than the manufacturer.
THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT
NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL GALLS AND/OR THE
MANUFACTURER BE LIABLE FOR ANY LOSS OF PROFITS OR ANY INDIRECT OR
CONSEQUENTIAL DAMAGES ARISING OUT OF ANY SUCH DEFECT IN MATERIALS
OR WORKMANSHIP.
SPECIFICATIONS
10 - 16 VDC (negative ground)
8.0 Amps @ 13.6 VDC (single 100W speaker)
16.0 Amps @ 13.6 VDC (dual 100W speakers)
Less than 150 mA
200Hz - 10 kHz + 3db
40 watts @13.6 VDC
105 WATTS RMS MAX. (15.0 VDC – single 100W speaker)
180 WATTS RMS MAX. (15.0 VDC –dual 100W speakers)
675Hz - 1633Hz
16 - 18 VDC will cause siren output to cease, resumes at normal voltage
50 AMPS (supply circuit must be capable of supplying this)
-15° F to +140°F
7-position rotary switch (Radio, PA, Manual, HF, Wail, Yelp, Thunder)
Momentary Manual/Horn rocker switch
Auxiliary input (jumper programmable) for positive or negative horn
-Remote Manual or Hands Free operation
Park Kill input (jumper programmable) for positive or negative activation
Thunder (and Two-Tone) disable (jumper programmable)
Two-Tone activation (swaps modes with Thunder) (jumper programmable)
Two LED indicators provide diagnostic feedback, one for each speaker
4 push-on/push-off buttons (1 programmable 8 sec. time delay)
4-position slide switch (Off, L1, L1 & L2, L1 & L2 & L3 & Wail)
20A fuse on each of the 7 light outputs. (4 push buttons, 3 slide positions)
Detachable, 12-pin, positive locking connector with pigtail leads.
(2) Positive, (2) Negative, (1) Activation (on/off), (1) Backlighting,
(2) Speaker, (2) Radio, Auxiliary, Park Kill
+12 – two 8 AWG leads
L1, L2, L3 (Slide Switch) and S1, S2, S3, S4 (Push buttons) 9-pin connector
6" Wide, 6-1/2" Deep, 3" High
6 lbs.
LIMITED WARRANTY
-16-