CORA CS1060 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol Suhu CORA CS1060. CORA CS1060 18 halaman. Temperature & humidity sensor

Extreme Long Life

To change the Sensor configuration:

Press the button slowly three (3) times (about 2 – 3 presses per second max) to enter

the configuration selection mode. The device will alternate green/red blink pattern

continuously once entered.

Then press the button slowly the corresponding number of times (e.g., 1,2, or 3) to

select the desired configuration.

If pressed more than four (4) times, the selection will be cleared and a new selection

specified. If no selection is made in 30 seconds, the device will exit configuration mode

without changes.

Once the choice of configuration is made, the device will stop the blink pattern, wait 30

seconds for no further input, apply the configuration change, and perform a network

reset.

After reset, the Sensor will be in the new operating mode.

The device configuration can also be changed using one or more of the configuration downlink

messages. Custom configurations are possible as well. Consult your application provider for

support.

CS1060 Temperature & Humidity Sensor – User Guide

•

Any relative humidity change of 10% on average (5

minutes running average);

•

Any changes of temperature exceeding 3.6°F (2°C) per

minute.

This configuration is useful for monitoring temperature

changes in refrigerators and freezers, where rapid

changes in temperature can indicate a door was left open.

Also detects long-term changes to indicate potential

equipment failure. Battery life is typically 2+ years.

Monitors changes in temperature using 10-minute

sampling interval. Notifies when temperature or humidity

exceeds thresholds and reports readings twice daily.

Battery health check sent once per day.

Sends notifications whenever conditions exceed the

following:

•

Any relative temperature change of 0.9°F (0.5°C) on

average (50-minute rolling average)

•

Any relative humidity change of 10% on average (50-

minute running average)

This configuration is useful for long term monitoring

temperature changes with equipment indicating potential

equipment failure. Battery life is typically 5+ years.

Page 7