Maico ERO SCAN Panduan Cepat

Jelajahi secara online atau unduh pdf Panduan Cepat untuk Peralatan Medis Maico ERO SCAN. Maico ERO SCAN 4 halaman.

ERO•SCAN

Screening and Diagnostic Version

The ERO•SCAN

The purpose of the ERO•SCAN

documentation of Distortion Product Otoacoustic Emissions (DPOAEs) or Transient Evoked

Otoacoustic Emissions (TEOAEs) at several frequencies.

Powering the Unit

To turn on the ERO•SCAN

display screen. The test will default to the protocol last selected. Press and hold the UP key to

turn the unit off.

Probe Tube and Eartips

D-0104938

– Quick Guide

test system is to provide a rapid measurement and

instrument press the  DOWN key located below the instrument's

Attaching Eartips:

Push the eartip onto the probe tube until it is flush against the collar

of the probe head. Be sure the eartip is fully seated on the probe.

Note: We highly recommend to use Sanibel

guarantee optimal test results.

Removing Eartips:

In order to remove the eartip, grasp the eartip at the base using the

eartip removal tool and pull it smoothly straight off the probe tube.

If you do not have a Removal tool at hand, grasp the eartip at the

base with your fingers and twist it while pulling it off the probe tube.

Probe Tube Replacement:

Probe tubes are disposable and should be replaced when they

become clogged. A package of replacement probe tubes is included

with this instrument. Do not attempt to clean the probe tube. To

replace the probe tube, use the eartip to grasp the probe tube (the

clear plastic tube) and twist slightly while pulling the probe tube

straight out of the probe head.

Dispose the used probe tube immediately to avoid confusing used

tubes and new tubes. Take a new probe tube from the package and

insert the tube into the probe head until it is fully seated. A properly

inserted probe tube will snap securely into place when it is fully

seated in the probe head.

Note: Only change the probe tube when it becomes clogged.

1 of 4

eartips in order to

12/15