Maico MV 16-1 Panduan Petunjuk Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Beralih Maico MV 16-1. Maico MV 16-1 13 halaman.
Halaman Cetak9 Commissioning
3. Mount housing on the wall. Suitable mounting
material is to be provided by the customer.
4. Guide the connection cables into the housing
through the grommets, check for leaks.
5. Wire motor protection switch in accordance
with wiring diagram.
The connection of the mains voltage must
be at the top, the connection of the motor(s)
must be at the bottom. Swapping the input
and output sides is not permitted. Only con-
nect thermal contact to terminals marked with
TB.
Connect the three connections for the shunt
opening release, together with the motor
cable, to terminals 2/4/6. Be sure to connect
the two upper connections to terminals C1/C2.
L1
L2
L3
PE
TB
TB
6. Fit housing cover and secure it with both
screws. Make sure the wrap-around seal is
correctly located in the upper part of the hous-
ing. NOTICE: Danger of short-circuits, caused
by moisture, if the housing is not fully sealed.
7. Install the fan(s).
9 Commissioning
1. Check that the technical data has been ad-
hered to → Rating plate.
2. Switch the mains fuse on, perform a function
test.
1
3
5
2
4
6
U
V
W
PE
M
3
10 Fault rectification
Fault rectification may only be undertaken
by a qualified electrician. Repairs may only be
carried out at the manufacturer's factory.
Fault: Main contactor of the motor protection
switch has triggered. The fan motor is separated
from the mains. A restart interlock prevents the
motor from switching on automatically.
Cause: Exceeding the temperature permitted in
the fan's motor winding/overheating of the TB fan
thermal contacts.
Depending on the fan, wait up to 30 minutes.
Rectify the fault if the fault persists. In order to
restart, first press the red button and then the
black button, so that the black button locks into
place.
If the fan is switched back on before the
motor has cooled down, it is retriggered
within 1 minute.
11 Disassembly, environmentally-
sound disposal
Old devices and electronic components may
only be dismantled by qualified electricians.
Proper disposal avoids detrimental impact on
people and the environment and allows valuable
raw materials to be reused with the least amount
of environmental impact.
Do not dispose of electronic com-
ponents in household waste! Dis-
pose of them in an environmentally
friendly manner and recycle them at
the appropriate collection points (→
Waste Management Act).
1. Separate the components according to mater-
ial groups.
2. Dispose of packaging materials (cardboard,
filling materials, plastics) via appropriate re-
cycling systems or recycling centres.
3. Observe the respective country-specific and
local regulations.
Company information
© Maico Elektroapparate-Fabrik GmbH. Trans-
lation of the original German operating instruc-
tions. Misprints, errors and technical changes are
reserved.
7