Galvin Engineering CliniLever TM-SNKGX Panduan Instalasi - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Produk Pipa Galvin Engineering CliniLever TM-SNKGX. Galvin Engineering CliniLever TM-SNKGX 6 halaman. Stainless steel lead safe gooseneck sink mixer
Product Installation Guidelines
TROUBLESHOOTING
PROBLEM
Tap is leaking
Tap has inconsistent flow
Tap moves on basin
Water temperature is opposite to the
handle markings
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but
not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download
from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free
from operational defects in workmanship and materials for the warranty period as shown on the schedule in
the manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any
defective products manufactured by Galvin Engineering without charge, so long as the terms of the
Manufacturer's warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for
breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
© Galvin Engineering Pty Ltd
CAUSE
Cartridge damaged
Tap incorrectly installed
Blocked flow regulator
Insufficiently tightened
Inlet hoses connected
incorrectly
Inlet hoses connected to wrong
isolating valves
Version 2.1, 2 December 2021, Page 6 of 6
RECTIFICATION
Remove and inspect the cartridge,
remove debris and/or replace if
damaged
Follow the installation steps above
when fitting the tap.
Follow the instructions above to
remove flow regulator from the body
and check for debris. Install an inline
strainer to stop further blockages.
Follow the steps above in relation to
tightening the installation.
Switch the hoses connection on the
inlets
Switch the hoses connection on the
isolating valves