Galvin Engineering GalvinAssist CP Panduan Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Produk Pipa Galvin Engineering GalvinAssist CP. Galvin Engineering GalvinAssist CP 6 halaman. Hand shower kit

Halaman Cetak

Product Installation Guidelines

5. Check Shower for operation and leaks

Check the hose is securely connected. Turn on

water supply. Once installation is completed, the

unit must be tested for any leaks.

Notes:

1. To comply with backflow prevention

standards, the hand spray must hang at least

55mm above the floor providing an 'air-gap'. If

the hand piece lies on the floor, then an

appropriate backflow prevention device must

be installed.

2. Shown is a Clevakit typical installation

conforming to AS1428.1-2009.

For Tapware

6. Fit spindle assembly

−

Remove handle and flange from cartridge

assembly. Unscrew the ¼ turn ceramic head

part from the threaded sleeve assembly and

screw ceramic cartridge into the valve body by

hand, tighten using a 17mm spanner.

−

Refit threaded sleeve and spindle.

The ¼ turn ceramic head part MUST be fitted into

the wall body prior to refitting the threaded

sleeve and spindle. DO NOT tighten cartridge by

using the spindle or the threaded sleeve.

Version 1, 1 June 2022, Page 4 of 6

Clevakit typical installation

Conforming to AS1428.1-2009

7. Fit wall flange

−

Ensure o-ring is fitted to the bottom of the

wall flange, and then hand-tighten the wall

flange onto the threaded sleeve.

Version 1, 25

May 2022, Page 4 of 6