AGS Parksafe Control Panel Panduan Pemasangan & Pengoperasian - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Pengontrol AGS Parksafe Control Panel. AGS Parksafe Control Panel 16 halaman. Ventilation control panel
Juga untuk AGS Parksafe Control Panel: Panduan Pemasangan & Pengoperasian (16 halaman), Pengoperasian & Pemeliharaan Instalasi (16 halaman), Panduan Pemasangan, Pengoperasian & Pemeliharaan (20 halaman)

Halaman Cetak
AGS Parksafe Control Panel Panduan Pemasangan & Pengoperasian
Installation & Operation Manual

Fault Status

You should contact your supplier immediately if FAULT appears as a detector status. This
message indicates an issue with the gas sensing module within the gas detector device.
Locate a Parksafe detector by matching the unique serial/ ID number.

End Of Life Status

This message indicates that the Parksafe detector has reached its expected operational
lifecycle. No gas levels will be displayed. Contact your supplier immediately.
The expected lifecycle will depend on the type of gas your detector is targeting and may vary
depending on environmental conditions.
For more information refer to your Parksafe detector manual.

Service Status

It is important to maintain the gas sensing elements of external detectors for optimum
performance and security of the system.
When detector status displays the 'SERVICE' message contact your supplier immediately.
Parksafe detectors will still operate as intended but its sensitivity can be inhibited by external
factors such as, dust; humidity; temperature fluctuations; cleaning products; contaminants or
sensor drift (ageing). All can cause a decline in sensitivity and eventual failure.
It is recommended that Parksafe detectors are inspected and serviced at least annually from
the date of installation for optimum performance and protection.
Contact your supplier for more information.

General Maintenance

 DO carefully remove any accumulated dust from outer enclosures once a month.
NEVER use detergents or solvents to clean your devices – this may permenantly or temporarily
damage the gas sensing elements.
NEVER spray lighter gas, paint or other aerosols near your devices.
NEVER paint devices. Paint will seal vents and may cause interference.
Avoid exposure of high concentrations of alcohol found in many products, this can damage,
deteriorate or affect the gas sensing elements. For more information refer to your Parksafe gas
detector manual.
AGS Parksafe - IOM Iss: DRAFT 3 06-20
Parksafe Control Panel
10