Hikari H93S Buku Petunjuk - Halaman 6
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mesin Jahit Hikari H93S. Hikari H93S 20 halaman. Electrical control box
Halaman Cetak
II． System Function Setting Description
1. System Info：
Operation panel default mode， press the button "
state。through the
Code No.
speed of motor control
U1
Motor Current
U2
U3
Motor Voltage
U4
Pedal voltage
U5
Mechanical Angle with
U6
Motor initial Angle
U7
Head type
U8
DSP version no.
U9
DSP type
U10
Step version no.
U11
Step foot lift current
VER
HMI Master chip version
TYPE
HMI type
AD1
Knee control sensor voltage
AD2
Foot lifting sensor voltage
H1
HMI Chip（STM32）version no.
H2
Model type
JJ
Plan number(plus)
Jp
Plan number(minus)
DX
Lower thread test
Press the button"
"key back to sewing mode。
2.Planning state：Plus/Minus
Press the button"
the button
current plan number， press
current data，press"
Remark：
（1）The quantity back to zero，long press
（2）Setting parameter no. P35 used for valid plan number：
（3）Setting decreasing function should change the parameter no. P38
（4）Setting decreasing function, "JP" key appear on the screen
（5）Plan number error：PBOB
key choose parameter at the project 。
Description
+
setting"key enter JJ plan number state under sewing mode， and then press
key could exchange "JJ & DX"and"JP" key，parameter on the screen is showed
key exchang the display bow，press
"key back to sewing mode。
+
" key， enter the system monitoring
key 3 secong under the system monitoring state。
3
Unit
rpm
0.01A
V
0.01V
limit
limit
JIA
V100
F73
V1xx
0.01A
v1xx
C104
1mV
1mV
V1xx
1969
Piece
Piece
cm
key could adjust the