Galvin Specialised Ezy-Drink TD00L-RM Panduan Instalasi Produk - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi Produk untuk Produk Pipa Galvin Specialised Ezy-Drink TD00L-RM. Galvin Specialised Ezy-Drink TD00L-RM 4 halaman. Lever action bubbler tapware

Halaman Cetak

TROUBLESHOOTING

PROBLEM

Inconsistent flow

Water is not flowing from tap

Continuous flow

Rate of flow inadequate

Button hard to press

WARRANTY

The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty

Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.

Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including

but not limited to the implied warranties of merchantability and fitness for a particular purpose.

Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download

from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free

from operational defects in workmanship and materials for the warranty period as shown on the schedule in

the manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any

defective products manufactured by Galvin Engineering without charge, so long as the terms of the

Manufacturer's warranty are complied with.

The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy

for breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or

consequential damages, including without limitation, lost profits or the cost of repairing or replacing other

property which is damaged if this product does not work properly, other costs resulting from labour charges,

delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,

chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty

shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or

alteration of the product.

CAUSE

Blocked top assembly

Water is turned off

Blocked flow restrictor

Top assembly loose or internally

obstructed or damaged

The flow regulator screw may not be

adjusted correctly

The mains pressure may be too

great

Version 2, 31 July 2017, Page 4 of 4

RECTIFICATION

Remove top assembly and clean

Turn on water

Remove restrictor and clean

Remove top assembly, clean with water

and re-grease spindle if required

Remove blanking screw and adjust flow

regulating screw as described

Reduce to below 500kPa (70PSI).

Regrease spindle if required