Galvin Specialised Ezy-Wash TF85-J Panduan Instalasi Produk - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi Produk untuk Perlengkapan Dapur & Kamar Mandi Galvin Specialised Ezy-Wash TF85-J. Galvin Specialised Ezy-Wash TF85-J 5 halaman. Pre-rinse tapware

Halaman Cetak

Retro-Fit {Installation to existing Galvin Specialised Ezy-Wash Pre-Rinse unit (the unit will need to be isolated

at the control valves)}

1. Disassemble wall bracket

 Unscrew the compression nut from the wall

flange using two spanners (1

wall flange, 2

for the compression nut).



Pull out support rod from wall flange and

loosen the support rod from upper riser hook

(if required).

3. Fit pot filler and riser

 Remove protective cap from upper riser

spindle

 Fit the upper riser to the lower riser,

ensure the sealing o-rings are inside the

spindle

 Tighten with new supplied grub screw.

It is critical that the grub screw point

locates accurately into hole recess of

mating part. Failure to do so may result

in damage and/or failure of the unit.

2. Disassemble pre-rinse riser

to support the

4. Fit pre-rinse riser assembly

Version 2, 4 August 2017, Page 3 of 5

Unscrew grub screw from top riser



assembly.

Separate top riser, paying special



attention to not damage any o-rings.

Remove pre-rinse unit body from hub



mounted assembly (if required).

 Screw support rod into the riser hook and

ensure it is not fully tightened (if applicable).

Fit compression nut to support rod,

followed by the compression cone and

locate the support rod into wall bracket.

Fit the pre-rinse riser assembly through the

drilled hole on the bench and secure.