Corally TOROX 185 Buku Petunjuk - Halaman 2
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengontrol Corally TOROX 185. Corally TOROX 185 8 halaman.
Halaman Cetak
WARNINGS
- Make sure that all wires and connections are properly insulated before connecting the ESC to the motor and battery.
A short circuit can cause irreparable damage to the ESC.
- Make sure all devices are properly connected, a poor connection can result in loss of vehicle control or damage to the
ESC.
- Read the manuals of all power supplies and make sure that the power supply configuration is correct before using this
ESC.
- Please use a soldering iron with a power of at least 60W to solder all inputs/outputs cables with connectors.
- Do not hold the vehicle in the air or start it at full throttle, as rubber tires can «expand» to an extreme size and even
crack and cause serious injury.
- Stop using the ESC when the temperature of its housing exceeds 90°C/194°F, otherwise the ESC will be destroyed
and your engine may be damaged. We recommend setting the «ESC Thermal Protection» to 105°C/221°F (this is the
internal temperature of the ESC).
- Please remove the ESC cooling fan before exposing the vehicle to liquids and dry it completely immediately after use.
- Always disconnect the batteries after use, as the ESC will always consume power if connected to the battery (even if
the ESC is off). A long-lasting contact will cause the battery to completely discharge and damage it. This will NOT be
covered by the warranty.
SPECIFICATIONS
Cont./Peak Current
Motor Type
Applications
Motor Limit
LiPo /NiMH Cells
BEC Output
Cooling Fan
Connectors
Size/Weight
Programming Port
CONNECTIONS
Please observe the connection diagram !
Brushless Motor
2
185A / 1050A
Sensorless/Sensored Brushless Motor(only in sensorless mode)
1/8th Buggy, Truggy, Truck and On-road
Brushless Motor Limit with 6S LiPo / 18 Cell NiMH: KV≤1500 (5892 size motor)
Brushless Motor Limit with 8S LiPo / 24 Cell NiMH: KV≤1200 (5892 size motor)
3-8S LiPo / 9-24 Cell NiMH
6V/7.4V Switchable, Continuous Current of 6A (Switch-mode)
Powered by the stable BEC voltage of 6V/7.4V
Input End: No Connectors
Output End: 6.5mm Female Gold Connectors (pre-soldered onto the PCB of the ESC)
70 x 56 x 45.5mm / 240g
FAN/PRG Port
Speedcontroller
Temp. monitoring cable
Receiver
Power Switch
DO NOT reverse the polarity
LiPo Battery
Servo