Coram TUBULAR SHOWER PANELS Panduan Memulai Cepat - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perlengkapan Kamar Mandi Coram TUBULAR SHOWER PANELS. Coram TUBULAR SHOWER PANELS 9 halaman.

Halaman Cetak
17
Vertical strut installation
Opening
Wall
=
=
Ensure that the opening end of the panel is vertical and
the panel is parallel with the opposite wall.
a
b
20
a: Assemble the strut: Slide on the outer ceiling bracket and panel bracket. Lightly tighten the fitted grub screws.
b: Carefully place the strut assembly onto the glass, approximately 100mm from the edge (depending on your installation). Ensure the strut is vertical and mark the
position of the outer ceiling bracket onto the ceiling.
c: Remove the strut assembly. Drill a hole in the centre of the position marked using a 6mm drill bit, 30mm deep.
d: Insert the wall plug and fix the inner ceiling bracket to the ceiling using a 32mm screw and washer. Note: The opening in the inner ceiling bracket should be
parallel with the end of the panel.
Note: The screws and wall plugs supplied are for masonry walls. For lightweight walls i.e. stud partitions, plasterboard etc, use the correct type of fixings.
18
a
b
a: Unscrew the top section of panel bracket.
b: Remove the long grub screw fixing the two halves together.
c: Fix the wall bracket to the lower section of panel bracket using the 16mm screw.
ø 6
c
mm
100
mm
a
19
c
16mm
Wall
a: Carefully place the (reassembled) panel bracket onto the glass, approximately 100mm from the edge (depending
on your installation). Carefully measure the distance 'X' between the top of the panel bracket and the ceiling.
b: Trim the strut to length: X + 30mm.
21
d
32mm
a: Reposition the strut back onto the panel (with grub screws on the inside). Angle the top end into
the inner ceiling bracket, slide the outer ceiling bracket up the strut and screw onto the inner ceiling
bracket.
b: Lightly tighten the grub screw on the outer ceiling bracket.
c: From inside, slide the glass clamp up between the bracket and glass panel and tighten the grub
screw.
Ensure the strut is vertical and fully tighten both grub screws.
b
Ceiling
X
X + 30mm
100
mm
a
b
c
Inside
PAGE 8