Hiker H-901 Petunjuk

Jelajahi secara online atau unduh pdf Petunjuk untuk Alat Listrik Hiker H-901. Hiker H-901 2 halaman. Grommeting hand press

Halaman Cetak

STEP-BY-STEP ADJUSTMENTS & TIPS

Turning the dial counter clockwise will lower the bottom die for a larger gap and

turning the dial clockwise will raise the bottom die for less gap. Having the gap

too tight to begin with can cause problems, so it is always better to start with a

little extra gap.

3) Once you've adjusted the gap to approximately the thickness of the material,

insert a grommet into a sample resembling the intended application.

grommet goes on the top die with the barrel side pointing down, and the washer

goes on the bottom die with the curved side down.

4) Grommets with flat washers: After you've inserted a grommet, check to see if

the grommet spins in its hole. If so, turn the dial that is at the base of the bottom

die ½ turn clockwise, put the loose grommet you just inserted back on the die in

the correct direction and press the grommet again. This will close the grommet

further. Check the grommet again to see if it still spins in the material. Repeat

this process until the grommet has a tight fit and does not spin.

On harder material, such as SINTRA®, adjust bottom die for minimal

impressions on material. Note: The grommet only needs to curl over enough to

grab the washer.

Rolled-rim grommets with spur washers: Make sure the grommet and washer

are tight together with little to no space between grommet, material and washer.

5) Once you have adjusted the die to produce a perfect insertion in the desired

material thickness, tighten the wing-nut on the screw that goes into the bottom

die (under the base). This will hold the die and your setting firmly in place.

Once familiar with how to change the die setting on the HIKER H-901 hand

press, inserting grommets in varying material thicknesses will be a quick and

easy process that will produce quality results. Thank you for choosing HIKER.

ADDITIONAL GROMMETING PRESSES

H-307AS

Semi-Auto

Only $2995!

- Electric

- Feeds Grommet

- Manual Washer Loader

- Optional Laser Pointer

For more information, contact

your dealer or HIKER.

The

Available Sizes of

Self-Piercing Grommets

with Flat Washers:

#0 - 1/4" id

#1 - 5/16" id

#2 - 3/8" id

#3 - 7/16" id

#4 - 1/2" id

#5 - 5/8" id

All available in

Brass, Nickel or Black.

H I K E R

Grommets • Eyelets • Dual Feed Presses • Single Feed Presses • Manual Presses

INSTRUCTIONS

H-901

GROMMETING HAND PRESS

CAUTION: Die settings that are too tight can damage or break the hand press.

Read instructions carefully and adjust lower die to proper setting before using.

H901INS Rev. 11 1/05