Hiking DDS238-4 W Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur Hiking DDS238-4 W. Hiking DDS238-4 W 15 halaman.

WIFI led indication, if you push the setting button last 5s, the WIFI led will flash 1s

interval ,its means meter enter into the status of waiting for WIFI distribution network . if WIFI

led light on 5s , light off 0.1s ,it means meter connect the WIFI successfully.

Impulse led indication: it will flash with different speed according the current load of the

meter

Relay led indication: the led light off means relay switch on, the led on means relay

switch off .

Down bond: you can push this button to check the different data display , it will

reset the resettable active energy to zero when you push this button last 5s ,but total active energy

will not reset.

Setting button: if you push the setting button last 5s ,meter will enter into the status of

waiting for WIFI distribution network .if you want to reset status of WIFI distribution network,

you also can push the setting button last 5s.

6.1 Connection diagram

RS485 port , 2A and 1 B ,Impusle 6+ 5-

6.2 Installation

The meter can be installed on a 35 mm DIN rail

6.2.1 The meter can not installed and used until it is checked goods and sealed before delivery

6.2.2 The meter should be install in the water proof box indoor or outdoor . the meter's box should

be fixed on strong and flame-resistant wall with a recommended height of about 1.8 m , where

there is no corrosive gas around .

6.2.3 The meter should be install fully in accordance with connection diagram on the terminal

cover, it is better to use copper as the leading wire for connection. All screws should be tightened.

Terminal 1 and 2 is for