CORBERO FE 1240 S/0 Buklet Instruksi - Halaman 8

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kulkas CORBERO FE 1240 S/0. CORBERO FE 1240 S/0 8 halaman.
Juga untuk CORBERO FE 1240 S/0: Petunjuk Pengoperasian (20 halaman)

Halaman Cetak

Rear spacers

The plastic bag containing all relevant

documentation also contains two rear wall spacers

to be fitted into special slots on the back of the

appliance. Fit the spacers into the slots, taking care

to ensure that the arrow (A) is positioned as shown

in the figure. Next, turn them through 45¡ (arrow in

vertical position) until they lock into place.

Door reversal

Unplug the appliance before all operations.

To reverse the door, proceed as follows:

1. dismantle the lower hinge (3), pin (1) and the

screw (2);

2. slide the door out from pin (G),unscrew the pin

and reposition on the opposite side;

3. unscrew the left front foot and reposition on the

opposite side;

4. unscrew the two screws which mask the holes for

fixing the hinge from the left front side;

5. reassemble the door;

6. reassemble the lower hinge (turning it 180¡), the

pin and the screw on the opposite side, as shown

in the figure;

7. Unscrew the handle. Refit it on the opposite side

after having pierced the plugs with a punch.

Cover the holes left open with the plugs supplied

in the documentation pack.

Attention

After completion of the door reversibility

operation, verify that the door gasket is adherent

to the cabinet. If the ambient temperature is cold

(i.e. in Winter), the gasket may not fit perfectly to

the cabinet. In that case, wait for the natural

fitting of the gasket or accelerate this process by

heating up the part involved with a normal

hairdrier.

45°

PR60

D299

PR220