GAMA Electronics LRF12V1C-WPTX Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Penerima GAMA Electronics LRF12V1C-WPTX. GAMA Electronics LRF12V1C-WPTX 4 halaman.

WWW.GAMAINC.COM

Each transmitter has its own unique internal address along with the data as to which button is pressed and transmitted.

The receiver needs to be programmed to respond only to the specific transmitter it is intended to operate with. The

following steps configure the receiver to operate with a particular transmitter. Up to 30 transmitters can be programmed

to one receiver. Please read the entire programming procedure before starting. When the receiver enters program

mode, all previous transmitter addresses that were programmed will be erased from the receiver's memory.

1. Locate the pushbutton labeled "PROGRAM" on the receiver. Press and hold this button until the red LED next to the

program button illuminates (approximately 3 seconds). The receiver is now in the transmitter program mode. Release

the button. At this point all previously programmed transmitter addresses are erased from the receiver's memory.

2. To configure the receiver for a latching output, go to Step 4.

3. To configure the receiver for momentary output, press and release the UP button on the transmitter and verify that the

red program LED extinguishes and then illuminates (blinks once). Proceed to Step 5.

4. To configure the receiver for latching output, press and release the DOWN button on the transmitter and verify that

the red program LED extinguishes and illuminates (blinks once).

NOTE: Multiple transmitters can be programed to the receiver while it is in program mode. Press and release a

button on each transmitter that you want to program while the LED indicator is illumined. The receiver will be

configured for momentary or latching operation based on the last transmitter that is programmed to the

receiver.

5. To add additional remote controls to the system after the initial programming, repeat steps 1-4.

6. The receiver will return to normal mode if no transmitter buttons are pressed for 5-seconds. The red LED on the

receiver will blink rapidly, then extinguish. The receiver is now in the normal mode of operation. This completes the

programming instructions. The receiver will retain all of its programming even when power is removed.

1. Press and hold the program switch until the front panel LED illuminates.

2. Release the program switch and immediately press and hold the program switch a second time.

The LED will start blinking and then blink very rapidly. Once the LED begins blinking rapidly,

release the program switch. The receiver memory is now clear.

Programming Instructions

RFR12V1C

Instruction Manual

Page 2 REV C 07/22/20