AFL ASCEND Petunjuk Instalasi
Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Perangkat Keras Jaringan AFL ASCEND. AFL ASCEND 4 halaman. Splice cassette
Juga untuk AFL ASCEND: Petunjuk Instalasi (4 halaman)
Halaman CetakTHE ASCEND
INSTALLATION INSTRUCTIONS
This document describes the recommended use of the ASCEND Platform.
TABLE OF CONTENTS
RACK MOUNTING ..... .............................................................................................................................................................................. 1
CASSETTE INSTALLATION ..................................................................................................................................................................... 2
PATCH CORD INSTALLATION ................................................................................................................................................................. 2
TRUNK CABLE INSTALLATION .............................................................................................................................................................. 3
LC UNIBOOT REVERSIBILITY ................................................................................................................................................................. 3
MTP
PRO REVERSIBILITY ..................................................................................................................................................................... 3
®
RACK MOUNTING
MATERIALS
INSTRUCTIONS
The ASCEND housing is optimized for use with a 19" rack or cabinet with standard rails that meet the EIA/ECA Standard for Cabinets, Racks, Panels, and Associated
Equipment. Note that mounting in a 23" rack requires an optional mounting hardware kit. It is recommended to start from the bottom of the rack or cabinet if the
intention is to completely fill the rack or cabinet with ASCEND housings.
1.
Determine the desired RU on which to mount the housing within the rack or cabinet.
2.
Partially install two positioning screws at the lowest position within the selected RU on the rack. Be sure
to leave enough space between the head of the screw and the rack rail to accommodate the thickness of
the housing mounting brackets.
3.
Place the housing between the rails on the rack while aligning the bottom slots of the mounting bracket
over the partially installed mounting screws. Once aligned over the screws, the weight of the housing can
be released. Install additional screws to the mounting bracket for stability.
4.
Tighten all screws completely (Figure 1).
4.18.19
PLATFORM
™
(800) 235-3423 • (864) 433-0333 • AFLglobal.com
1. ASCEND Housing
2. Rack Mounting Hardware
Figure 1
1