AGS Mini Merlin CH4CO Panduan Pemasangan & Pengoperasian - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Sensor Keamanan AGS Mini Merlin CH4CO. AGS Mini Merlin CH4CO 16 halaman. Dual gas detector, methane & carbon monoxide gas
Juga untuk AGS Mini Merlin CH4CO: Panduan Pengguna (16 halaman)

Halaman Cetak

1. Wiring the Device

Installation & Operation Manual

OPERATION

First Power Up

Supply mains electrical supply and press and hold the touch button for 3 seconds.

The device enters 'sensor stabilisation' phase for approximately 60 seconds – during this period

the screen will display an 'initialisation' message indicating that the device is not yet ready for

gas detection.

To switch your device off - remove or switch off the mains power supply.

Gas Level Display

At dangerous gas levels, the alarm will continuously sound if the buzzer dip-switch is ON.

Only when gas levels are at a safe level will the audible alarm stop.

Audible Alarm Characteristics

NO ALARM – Gas concentration levels are safe. No alarm sound.

PRE- ALARM – Alarm will 'beep' every 15 seconds.

ALARM – Continuous alarm sound.

The alarm will only sound if the Buzzer is switched to ON.

Rev: 12 01-20

There are no provisions to silence this alarm.

AGS Mini Merlin CH4CO