Gama Garden GCS-2200E Buku Petunjuk - Halaman 12

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Gergaji Gama Garden GCS-2200E. Gama Garden GCS-2200E 18 halaman. Electric chain saw

Halaman Cetak

Chainsaw protection

Never use the chainsaw in the rain or in damp

conditions.

If the extension cable is damaged, pull the

plug out of the power socket immediately.

Never work with a damaged cable.

Check the chainsaw for damage. Before using

your tool again, check the safety devices or any

slightly damaged parts to ensure that they are in

good working order. Make sure the moving parts

are working correctly. All the parts must be

correctly assembled and meet all the conditions

required to ensure that the chainsaw works

correctly. Any damaged safety devices and parts

must be properly repaired or replaced immediately

by a Customer Service workshop, unless there

are

instructions

operating instructions.

Notes on working practice

Kickback (Fig 7)

You can avoid accidents by not sawing with

the tip of the guide bar as this may cause the

saw to rear up suddenly.

Always use the complete safety equipment

and clothes when working with the saw.

Kickback is an upward and/or backward

movement of the guide bar which can occur if the

saw chain at the tip of the guide bar encounters

an obstruction.

Make sure your work-piece is firmly secured. Use

clamps to stop the work-piece slipping. This also

makes it easier to operate the chainsaw with both

hands.

Kickback causes the saw to behave uncontrollably

and thus brings with a slack or blunt chain. A

poorly sharpened chain increases the risk of

kickback. Never saw above shoulder height.

Tips on chain saw use

Sawing up wood (Fig 6a, 6b)

To saw up wood, please observe the safety

regulations and proceed as follows: Make sure

the wood to be sawed cannot slip. Clamp short

pieces of wood in place before sawing. Saw only

to the contrary

in these

wood or wooden objects. When sawing, make

sure that no stones or nails are touched as these

could be thrown out and damage the saw chain.

Avoid bringing the running saw into contact with

wire fences or the ground. When lopping off

branches, support the chainsaw as far as possible

and do not saw with the tip of the guide bar. Watch

out for obstacles such as tree stumps, roots,

ditches and hillocks as these could cause you to

fall.

Position the chainsaw in such a way that your

body is clear of the cutting attachment whenever

the saw is running. Stand to the left of cut while

bucking (Fig 6a).

Don't put pressure on the saw when reaching the

end of a cut. The pressure may cause the bar

and rotating chain to pop out of the cut or kerf, go

out of control and strike the operator or some

other object. If the rotating chain strikes some

other object, a reactive force may cause the

moving chain to strike the operator.

Remember:

The chainsaw must be running before it comes

into contact with the wood.

To switch on: Press the safety lock-off and ON/OFF

switch on. Place the lowest claw (Fig 6b) on the

wood. Raise the chain saw by the rear grip and

saw into the wood. Move the chain saw back a

little and place the claw further down. Be

careful when sawing splintered wood as pieces of

wood may be ripped off.

Wood under tension

Fig. 1Oa: Top side of under tension

Danger: Tree will rear up!

Fig. 1Ob: Bottom side of trunk under tension

Danger: Tree will move downwards!

Fig. 1Oc: Thick trunks and high tension

Danger: Tree will move suddenly and

with immense force!

Fig. 1Od: Both sides of trunk under tension

Danger: Tree will move sideways.

Felling trees

To fell trees, observe all the safety regulations

and proceed as follows: