HIKOB Wise Cow Dokumentasi Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Dokumentasi Pengguna untuk Aksesori HIKOB Wise Cow. HIKOB Wise Cow 13 halaman.

HIKOB WISE COW

Version 1.1-2466

undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instruction, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception which can be determined by turning

the equipment off and on, the user is encouraged to try to correct interference by one or more

of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on circuit different from that to which the receiver

is connected.

– Consult the dealer or an experienced radio/TV technician for help.

RF exposure This device complies with FCC RF radiation exposure limits set forth for gen-

eral population. This device must be installed to provide a separation distance of at least

20cm from all persons and must not be co-located or operating in conjunction with any other

antenna or transmitter.

1.3.4 Canada

Transmitter Antenna Under Industry Canada regulations, this radio transmitter may only

operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter

by Industry Canada. To reduce potential radio interference to other users, the antenna type

and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is

not more than that necessary for successful communication.

Licence-Exempt Radio Appartus This device complies with Industry Canada licence-exempt

RSS standard(s). Operation is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

RF Exposure This device complies with Industry Canada RF radiation exposure limits set

forth for general population. This device must be installed to provide a separation distance

of at least 20cm from all persons and must not be co-located or operating in conjunction with

any other antenna or transmitter.

November 2015 Page 5/ 14