Dynomax 19389 Panduan Petunjuk Instalasi
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Suku Cadang Mobil Dynomax 19389. Dynomax 19389 2 halaman. 2004 dodge durango w/4.7l, 5.7l v8 engines, 2wd/4wd
Halaman Cetak
INSTALLATION INSTRUCTIONS FOR
DYNOMAX DUAL KIT: 19389
2004 Dodge Durango w/4.7L, 5.7L V8 Engines,
2WD/4WD
DANGER WARNING: SHOULD THE PURCHASER DECIDE TO INSTALL
ANY EXHAUST PRODUCT AT HOME, BE WARNED THAT PASSENGER
CAR OR LIGHT DUTY TRUCK/VAN "BUMPER" JACKS ARE INTENDED
FOR EMERGENCY USE ONLY. THE USE OF FRAME CONTACT JACK
STANDS IN CONJUNCTION WITH A FLOOR JACK AS MAIN SUPPORT
IS HIGHLY RECOMMENDED TO MINIMIZE ACCIDENTAL DROPPING
OF A VEHICLE DURING THE INSTALLATION PROCESS.
NOTE: Read all instructions before starting any work.
1. Remove the OE front muffler assembly and the OE rear resonator assembly.
To assist in removal, it is recommended that the rubber hanger isolators be
lubricated with WD-40 or a similar product.
2. Install DynoMax front pipe 41801 to the outlet of the converter/y-pipe assembly.
The rod hanger should slip into the the rubber isolator located off the passenger
side frame rail. Finger tighten the supplied 2³⁄₄" U-Bolt clamp onto the inlet of
this pipe.
3. Install DynoMax muffler 17665 onto the outlet end of pipe 41801. The outlet
end of the muffler is marked with the word 'OUTLET'. The muffler body should
lie flat when properly installed with the muffler inlet connection closes to the
drive shaft. Finger tighten a 3" U-Bolt clamp onto the muffler inlet connection.
(If equipped, attach the OE electrical grounding strap nut to one of the muffler
clamp u-bolt ends when performing the final tightening sequence. See step 6.)
4. Install rear extension pipe 52225 into the outlet of the muffler. Position the two
rod hangers into the proper rubber isolators above the rear of the muffler. The
two rod hangers should point toward the rear of the vehicle when properly
installed. Finger tighten a 3" U-Bolt clamp onto the muffler outlet connection
to this pipe.
5. Install tail pipe 55211 onto the outlet of pipe 52225. Slide the tail pipe rod
hanger into the two rubber isolators at the rear of vehicle.
6. Beginning from the inlet end, position all components and tighten clamps.
Please see full system diagram on the back page.
KIT CONTAINS:
(1) 17665 MUFFLER
(1) 41801 PIPE
(1) 52225 PIPE
(1) 55211 PIPE
(1) 2³⁄₄" CLAMP
(3) 3" CLAMPS
(1) INSTRUCTION SHEET
2701 N. Dettman Rd.
Jackson, MI 49201
Form: 700037
04/04