Jadak Bar Code Scanner Petunjuk Instalasi
Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Pembaca kode batang Jadak Bar Code Scanner. Jadak Bar Code Scanner 4 halaman. Fujifilm sonosite
Halaman Cetak
Bar Code Scanner (USB)
Installation Instructions
Follow these instructions to connect and program any of these USB bar code scanners:
•
JADAK flexpoint HS-1M on the X-Porte, Edge
•
Symbol LS2208 on the NanoMaxx, M-Turbo, or S Series ultrasound system
When connected, the bar code scanner is listed on the system's USB or USB Devices setup page.
See the Bar Code Scanner User Guide from FUJIFILM SonoSite for information on safety and cleaning.
Configuring the JADAK bar code scanner
To connect and program the Jadak bar code scanner
1 Attach the scanner cord to the bar code scanner and to a USB port on the ultrasound system.
See JADAK flexpoint HS-1
For location of USB ports, see the ultrasound system user guide or Help (X-Porte only).
2 Turn on the ultrasound system.
3 Scan the following two bar codes in the order listed:
USB Kybrd
STX Prefix
ETX Suffix
DOS CTRL
ASCII MODE
4 To ensure the scanner has been configured to work with your ultrasound system, FUJIFILM SonoSite
recommends opening a patient information form on your system and scanning a bar code. Your system is
successfully configured when you scan a bar code and the patient ID (and associated patient information, if
any) populates the patient information form.
Configuring the Symbol bar code scanner
To connect and program the Symbol bar code scanner
1 Attach the scanner cord to the bar code scanner and to a USB port on the ultrasound system.
See Symbol LS2208 Quick Start Guide included with the bar code scanner.
For location of USB ports, see the ultrasound system user guide.
,
M
Quick Start Guide included with the bar code scanner.
M-Turbo, S Series, or NanoMaxx ultrasound system