Jade JMRH Series Panduan Pemasangan & Pengoperasian - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Rentang Jade JMRH Series. Jade JMRH Series 20 halaman. Titan series super heavy duty range line
Halaman Cetak
Gas Leak Check
WARNING
TEST ALL PIPE JOINTS FOR LEAKS BEFORE
OPERATING THIS APPLIANCE. THIS INCLUDES
ALL GAS CONNECTIONS THAT MAY HAVE
LOOSENED DURING SHIPMENT. DO NOT USE
THE APPLIANCE IF ANY LEAKS ARE DETECTED.
After gas connections are compete and tightened,
use an approved liquid leak detector or
combination of liquid soap and water in a spray
bottle to test all installed fittings. Check for the
smallest bubbles that can indicate a leak. Correct
all leaks before operation of the appliance.
WARNING
RISK OF FIRE, EXPLOSION, BODILY HARM OR
DEATH. DO NOT USE AN OPEN FLAME TO
CHECK FOR LEAKS!
BURNER FLAME ADJUSTMENTS
NOTE: All burner flames have been adjusted at
the factory, occasionally onsite fine-tuning may
be necessary, see below for proper burner flame
adjustment.
Flame Characteristics for a
Properly Adjusted Burner
A correctly adjusted burner produces a flame that
makes contact with the burner and makes the same
contact all along or around the burner. It should be
sitting on the burner and should be dark blue at the
bottom and light blue at the top. It should be steady,
not dancing or jumping (indication of too much
primary air). This is true for both natural gas fig. (7A)
and LP gas. LP gas may exhibit light yellow tips fig.
(7B). There are several problems that can happen if
the air and fuel mixture is not delivered to the burner
correctly fig. (7C).
IO-10
Titan
Model Series JTRH & JTRHE
A
B
Figure 7: Burner Flame Characteristics
Top Burner Pilot Adjustment
Locate the pilot adjustment screw as shown on
the illustration below. Adjust the screw until the
pilot intersects the gas jets on burners.
Figure 8: Top Burner Pilot Light Adjustment
Jade Range LLC – A Middleby Company
TM
Series Heavy Duty Range
CORRECT FLAME
C