Corbin Russwin ASSA ABLOY Access M806 Instruksi Pemrograman - Halaman 15

Jelajahi secara online atau unduh pdf Instruksi Pemrograman untuk Dengan kunci Corbin Russwin ASSA ABLOY Access M806. Corbin Russwin ASSA ABLOY Access M806 16 halaman.

Halaman Cetak

Access 800

Series

™

Locks

Keypad Programming Instructions

M802 and M805 Programming

In a Prox Only M802 or RF Technology & Prox M805 configuration, all programming must be completed

using AccesswareTM Software. The Software includes a convenient Software User's Manual in .pdf

format to be used as a programming guide. After setting up your system using the software, Hotsync to

the PDA. Be sure to program a "Communications Enable" credential for future programming.

To program the lock for the first time or after memory is reset, the following steps are required.

1. Use AccesswareTM software to set up your system and Hotsync door information to PDA.

2. Remove Battery Cover from inside of lock.

3. On PDA - select "Access HH", then "Imp/Exp"

"Do NOT click OK at this point"

4. "Wake up" the M802 or M805 lock by presenting

any HID Prox Credential or by depressing an RF FOB

5. Within a couple seconds press and hold the controller CommEnable push button (white button

located in the battery compartment) for 2 seconds, then release the button.

6. On the PDA, click "OK"

If there was an error, check connections and repeat process starting at Step 3.

Note: The Credential will NOT actuate the lock for 45 seconds from the start of the downloading

process. After this time expires, the Credential will function as defined by its User Type.

Reprogramming

Note: Using the proximity card, FOB, tag or RF FOB programmed as a "CommEnable" User,

present the "CommEnable" credential to the lock to initiate communications after performing

Step 3 (above) without the need to press the CommEnable button.

For installation assistance contact Corbin Russwin

1-800-543-3658 • [email protected]

express written permission of Corbin Russwin, Inc. is prohibited.

PDA Response: "Please enter your

communications code at the door"

Lock Response: Audible beep

The PDA will begin transferring (0-100%) of

the door data to the lock.

(617417440) FM359 7/19