AGT AGT-SSDFM60 Panduan Produk - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Produk untuk Peralatan Pertanian AGT AGT-SSDFM60. AGT AGT-SSDFM60 17 halaman. Skid steer forestry disc mulcher
Halaman Cetak
Installation
Unpack and check
Check for missing or damaged components according to the packing list.
If you have any questions, please contact the supplier. List of details As the table above:
Machine installation
Equipment must be installed on a solid concrete floor or similar. If the ground is not firm,
it will not be able to connect to the loader. There should be a space around the device for
easy operation.
Connecting Forestry Disc Mulcher
Consult your skid steer operator's manual for specific instructions on how to connect
your Forestry Disc Mulcher to your skid steer loader.
General Attachment Method
1. Make sure the hydraulic lines are clear from the front side of the brush cutter's
attachment plate and that the locking pins on the skid steer mounting plate are retracted.
2. Drive forward and place top of skid steer mounting plate under the attachment mounting
flange. See Figure below.
3. Slowly raise and tilt back the skid steer mounting plate untilthe brush cutter attachment
plate rests flat against the skid steer mounting plate.
4. Activate your skid steer's lever lock switch to engage and lock the pins into the flange
slots of the brush cutter's attachment plate. If your skid steer does not have this
switch, push the latch handles down until you can see the lock pins extend into the
attachment flange.
5.Connect the attachment hydraulic hoses and the case drain hose (SBCNS
model only) to the auxiliary supply couplers located on your skid steer loader lift
arm.
Skid Steer Mounting Plate to Attachment Mounting Flange
https://www.agrotkindustrial.com/
5