Dea 124RR Petunjuk dan Peringatan - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk dan Peringatan untuk Panel Kontrol Dea 124RR. Dea 124RR 11 halaman. Control board 24v for gate automation operating

Halaman Cetak

Operating instructions and warnings

WARNING DEA System reminds all users that the selection, positioning and installation of all materials

and devices which make up the complete automation system, must comply with the European Directives

98/37/CE (Machinery Directive), 89/336/CE and subsequent amendments (electromagnetic compati-

bility), 73/23/CE and subsequent amendments (low voltage electrical equipment). In order to ensure a

suitable level of safety, besides complying with local regulations, it is advisable to comply also with the

above mentioned Directives in all non-European countries.

5 TECHNICAL DATA

Power supply ....................................................230 V a.c. +/- 10% 50Hz

Flashing light output .........................................24 V d.c. max 15W art. Lumy 24S

Auxiliary power supply output (+24VAUX) ..........24 V d.c. (max 200mA)

Safety devices power supply output (+24VSIC) ...24 V d.c. (max 200mA)

LC/SCA contact capacity LC/SCA ......................max 5A

Max motor capacity ..........................................70W max

Fuse F1 ............................................................T1A

Fuse F2 ............................................................T10A

Radio receiver frequency ...................................433,92 MHz rolling code / dipswitch coding

Max. number of transmitter controlled................100

6 OPERATING CONDITIONS

124RR control board is designed for the automation of DEA System gates operators in 24V a.c., and

therefore it is fit for overhead doors, sliding gates and barriers.

This control board is designed and tested for operation under "normal" conditions for both residential

and industrial use. The level of protection against dust and water and other data are illustrated in the

instructions booklet of each gate operator DEA System, equipped with the 124RR control board.

WARNING Using the product under unusual conditions not foreseen by the manufacturer may cause

dangerous situations; this is the reason why all the conditions prescribed in these instructions must be

followed.

WARNING Under no circumstance must the product be used in an explosive environment or surroun-

dings that may prove corrosive and damage parts of the product.

WARNING To ensure an appropriate level of electrical safety always keep the 230V cables (power sup-

ply) apart from low voltage cables (motors power supply, controls, aerial and auxiliary circuits power

supply), and fasten the latter with appropriate clamps near the terminal boards.

WARNING Any installation, maintenance or repair operation on the whole system must be carried out

exclusively by qualified personnel. All these operations must be performed only after disconnecting the

power supply, and operating in strict compliance with the electrical standards and regulations in force

in the nation of installation.

WARNING Install and wire the control board according to the instructions given in the instruction

booklet of each gate operator DEA System (such as hole drilling to allow for wires passage, use of wire

clamps, etc.)

Failure to comply with these instructions may jeopardize the level of electrical safety.

Connect to the power supply 230 V a.c. ± 10% 50 Hz through a multi pole switch or a different device

that can ensure multi pole disconnection from the power supply, with a contact opening of 3 mm. Use a

cable with a minimum section of 3 x 1,5 mm² (e.g. a H07RN-F type).

Make all connections to the terminal board and remember to short-circuit, whenever necessary, all

unused inputs. (See table 1 terminal board connection and Fig. 1 wiring diagram)

ASSEMBLY AND WIRING INSTRUCTIONS

250V (retarded)