Mains MV4k/1 Petunjuk Manual - Halaman 11

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Pengontrol Mains MV4k/1. Mains MV4k/1 18 halaman. Checkout controller

Controller MV4K - description of the panel

Digital programmable belt controller

Buttons:

1. Turning on or off the conveyor belt in automatic mode with the use of photocells.

2. Turning on the operation belt mode, controlled with the use of the footswitch.

3. Switching L1 circuit (first pressing - continuous signal, second pressing - intermittent signal).

4. Safety switch - disconnects the power supply terminal phase

STOP – in case of any emergency, you must press the button!

This will immediately disconnect the power supply and stop the motor.

This function is to be used only in emergency situations!

5. Main power switch – turns on the power of the controller and the circuit of the lamp 2

LEDs:

SERVICE – signals the need to service review of the unit.

- indicates the activation of the elevation motor cover sensor.

S.START – indicates that the motor soft start function is turned on

OUT – indicates the type of applied voltage for additional output - either continuous or intermittent.

CTRL – indicates motor operation.

MAINS S.C. E.M.Wosińscy Brzeziny 95-060 ul. Słowackiego 12, tel/fax: 48 46 8752 777 www.mains.pl; [email protected]

Front panel of the MV4K

SERVICE

S. START

OUT

CTRL

Description of the panel

Mv4k

POWER

controller: Mv4k