HIKOKI D 10VST Manual Petunjuk Penanganan - Halaman 16

Jelajahi secara online atau unduh pdf Manual Petunjuk Penanganan untuk Bor HIKOKI D 10VST. HIKOKI D 10VST 20 halaman.

English

The larger the drill bit diameter, the larger the reactive force on your arm.

○

Be careful not to lose control of the drill because of this reactive force.

To maintain ﬁ rm control, establish a good foothold, hold the drill tightly with both hands, and

ensure that the drill is vertical to the material being drilled.

MAINTENANCE AND INSPECTION

Inspecting the drill bits

Since use of an abraded drill bits will cause motor malfunctioning and degraded eﬃ ciency,

replace the drill bits with a new one or resharpening without delay when abrasion is noted.

Inspecting the mounting screws

Regularly inspect all mounting screws and ensure that they are properly tightened. Should

any of the screws be loose, retighten them immediately. Failure to do so could result in

serious hazard.

Maintenance of the motor

The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the

winding does not become damaged and/or wet with oil or water.

Inspecting the carbon brushes

For your continued safety and electrical shock protection, carbon brush inspection and

replacement on this tool should ONLY be performed by a HiKOKI Authorized Service

Center.

Replacing supply cord

If the replacement of the supply cord is necessary, this has to be done by HiKOKI

Authorized Service Center in order to avoid a safety hazard.

If the supply cord of this power tool is damaged, it must be replaced by a specially prepared

cord available through the service organization.

Service parts list

CAUTION

Repair, modiﬁ cation and inspection of HiKOKI Power Tools must be carried out by

a HiKOKI Authorized Service Center.

This Parts List will be helpful if presented with the tool to the HiKOKI Authorized

Service Center when requesting repair or other maintenance.

In the operation and maintenance of power tools, the safety regulations and

standards prescribed in each country must be observed.