DEAD FLY ZONE AMS-S1 Petunjuk Perakitan - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Perakitan untuk Penerima DEAD FLY ZONE AMS-S1. DEAD FLY ZONE AMS-S1 4 halaman.
Halaman Cetak1) First set the current time by turning the minute hand clockwise.
2) Your timer has trippers of 15 minute increments and an AM/PM indication on the outer
dial. Push the trippers outward for the times you want the system to activate and spray.
A good rule of thumb in livestock situations would be to spray every 2 hours for
approximately 30 seconds per cycle, starting at dawn and ending at dusk or 7am to 7pm.
3) Turn the "Misting Time" knob for the desired time you want each cycle to spray. Again,
30-40 seconds is a good starting point.
4) Use the "Mist Now" button to spray extra times outside your designated programmed
times or when you need to test nozzles and do not want to disrupt your timer.
Filling The Tank and Setting The Spray Cycle
Fill your reservoir tank up about half way with just water. Then pour BOTH containers
(Vector Ban and SynerPro) into your tank. Make sure your hose is at the bottom of the tank to
prevent foaming and then continue to fill until your water level is about 6 inches from the top.
Using a broom handle or a piece of PVC pipe, give the tank a good stir. If you are using your
system for residential purposes and not livestock, you will only have a container of Vector Ban
Plus and no SynerPro. Follow the same instructions for filling.
If you purchased our stall deodorizer (Sweet Smellin' Stables), pour all of its contents in
the tank with the insecticide. Everybody goes into the pool together!
You will want to program your first spray cycle as soon as the sun comes up and it starts
to get warm. We recommend starting at 7am and then spraying every two hours until 7pm.
This will give you 7 spray cycles per day. We also recommend that you spray for approximately
30-40 seconds for each spray cycle. If you're still seeing flies, increase the spray time in 5-10
second increments.
Programming The Timer